Husqvarna 966976701 manual KEY to Symbols

Page 2

KEY TO SYMBOLS

Symbols

WARNING! The machine can be a dangerous tool if used incorrectly or carelessly, which can cause serious or fatal injury to the operator or others. It is extremely important that you read and understand the contents of the operator’s manual.

Please read the operator’s manual carefully and make sure you understand the instructions before using the machine.

Always wear:

A protective helmet where there is a risk of falling objects

• Approved hearing protection

• Protective goggles or a visor

This product is in accordance with applicable EC directives.

This machine is not electrically insulated. If the machine

touches or comes close to high- voltage power lines it could lead

to death or serious bodily injury. Electricity can jump from one point to another by arcing. The

higher the voltage, the greater the distance electricity can jump. Electricity can also travel through branches and other

objects, especially if they are

wet. Always keep a distance of at least 10 m between the machine and high-voltage power lines and/or any objects that are touching them. If have to work within this safe distance you should always contact the relevant power company to make sure the power is switched off before you start work.

This machine has a long reach. Make sure that no people or animals come closer than 15 m when the machine is running.

Always wear approved protective gloves.

Wear sturdy, non-slip boots.

Other symbols/decals on the

machine refer to special certification requirements for certain markets.

2 – English

The engine is switched off by moving the stop switch to the stop position. CAUTION! The stop switch

automatically returns to the start position. In order to prevent unintentional starting, the spark plug

cap must be removed from the spark plug when assembling, checking and/or performing maintenance.

Always wear approved protective gloves.

Regular cleaning is required.

Visual check.

Protective goggles or a visor must be worn.

Filling with chain oil and adjusting oil flow

Image 2
Contents 327P4 327P5X-series KEY to Symbols SymbolsContents Introduction Dear CustomerWhat is WHAT? What is what?General Safety Precautions Personal protective equipmentMachine′s safety equipment Throttle lockoutMuffler Stop switchVibration damping system Only use cutting equipment recommended by us Quick release Balance Flex harnessCutting equipment Chain Sharpening your chain and adjusting raker clearanceSpecification of bar and saw chain General Safety Precautions Tensioning the chain Filling with chain oil Adjusting chain lubricationLubricating cutting equipment Checking chain lubricationChain drive sprocket Checking wear on cutting equipment ChainWhat to do if lubrication does not work May increase the risk of accidentsFitting the cutting head AssemblyAdjusting the harness Fitting the bar and chainAssembling and dismantling the two-piece shaft AssemblyFilling with oil Fitting the impact guardAssembly of the saw attachment Fuel Fuel safetyFuel Handling Fuelling MixingStarting and stopping Starting and StoppingCheck before starting StartingStopping Working Techniques Safety instructions regarding the surroundingsSafety instructions while working General working instructionsSafety instructions after completing work Basic working techniquesWithout having the cutting attachment in full view Maintenance CarburettorLow speed jet L Fine adjustment of the idle speed TCorrectly adjusted carburettor High speed jet HSpark plug MufflerCooling system Is damaged it should be replacedAir filter Cleaning the air filterTwo-piece shaft Oiling the air filterMaintenance schedule Maintenance Daily Weekly MonthlyTechnical Data Technical dataBar and chain combinations Approved accessories Art No Use withEC-declaration of conformity Applies to Europe only Page Page Page Page 1150991-26