Husqvarna 966976701 Filling with oil, Assembling and dismantling the two-piece shaft, Assembly

Page 16

ASSEMBLY

Filling with oil

Open the cap on top of the bar head

Fill with Husqvarna saw chain oil.

Refit the cap.

Assembling and dismantling the two-piece shaft

(327P5)

Assembly:

Loosen the coupling by turning the knob.

Align the tab of the attachment (A) with the arrow on the coupling (B).

B

A

Push the attachment into the coupling until the attachment snaps into place.

Before using the unit, tighten the knob securely.

Dismantling:

Loosen the coupling by turning the knob (at least 3 times).

Push and hold the button (C). While securely holding the engine end, pull the attachment straight out of the coupling.

C

Fitting the impact guard

(327P5)

If the machine has a protective guard bolted under the engine this should be removed before the impact guard is assembled.

Fit the guard using the three screws and washers. Fit the two short screws in hole A. Tighten the screws to a torque

16 – English

Image 16
Contents 327P4 327P5X-series KEY to Symbols SymbolsContents Introduction Dear CustomerWhat is WHAT? What is what?General Safety Precautions Personal protective equipmentMachine′s safety equipment Throttle lockoutVibration damping system Stop switchMuffler Cutting equipment Quick release Balance Flex harnessOnly use cutting equipment recommended by us Specification of bar and saw chain Sharpening your chain and adjusting raker clearanceChain General Safety Precautions Tensioning the chain Adjusting chain lubrication Lubricating cutting equipmentFilling with chain oil Checking chain lubricationChecking wear on cutting equipment Chain What to do if lubrication does not workChain drive sprocket May increase the risk of accidentsAssembly Adjusting the harnessFitting the cutting head Fitting the bar and chainAssembly Filling with oilAssembling and dismantling the two-piece shaft Fitting the impact guardAssembly of the saw attachment Fuel Handling Fuel safetyFuel Fuelling MixingStarting and Stopping Check before startingStarting and stopping StartingStopping Safety instructions regarding the surroundings Safety instructions while workingWorking Techniques General working instructionsSafety instructions after completing work Basic working techniquesWithout having the cutting attachment in full view Maintenance CarburettorFine adjustment of the idle speed T Correctly adjusted carburettorLow speed jet L High speed jet HMuffler Cooling systemSpark plug Is damaged it should be replacedCleaning the air filter Two-piece shaftAir filter Oiling the air filterMaintenance schedule Maintenance Daily Weekly MonthlyTechnical Data Technical dataEC-declaration of conformity Applies to Europe only Approved accessories Art No Use withBar and chain combinations Page Page Page Page 1150991-26