Husqvarna 966976701 manual Quick release Balance Flex harness, Cutting equipment

Page 9

GENERAL SAFETY PRECAUTIONS

WARNING! The inside of the muffler

! contain chemicals that may be carcinogenic. Avoid contact with these elements in the event of a damaged muffler.

WARNING! Bear in mind that:

! The exhaust fumes from the engine are hot and may contain sparks which can start a fire. Never start the machine indoors or near combustible material!

Quick release (Balance Flex harness)

There is an easily accessible, quick release fitted at the front as a safety precaution in case the engine catches fire, or in any other situation that requires you to free yourself from the machine and harness.

Check that the harness straps are correctly positioned. Once the harness and machine have been adjusted, check that the harness quick release works correctly.

Cutting equipment

This section describes how you can achieve maximum clearing capacity and extend the life of the cutting attachment through correct maintenance and using the right type of cutting attachment.

Check the cutting equipment with regard to damage and crack formation. Damaged cutting equipment should always be replaced.

Only use cutting equipment recommended by us!

Keep the chain’s cutting teeth properly sharpened! Follow our instructions and use the recommended file gauge. A damaged or badly sharpened chain increases the risk of accidents.

Maintain the correct raker clearance! Follow our instructions and use the recommended raker gauge. Too large a clearance increases the risk of kickback.

Keep the chain properly tensioned! If the chain is slack it is more likely to jump off and lead to increased wear on the bar, chain and drive sprocket.

Keep cutting equipment well lubricated and properly maintained! A poorly lubricated chain is more likely to break and lead to increased wear on the bar, chain and drive sprocket.

WARNING! Never use a machine with

! faulty safety equipment. The machine’s safety equipment must be checked and maintained as described in this section. If your machine fails any of these checks contact your service agent to get it repaired.

WARNING! Always stop the engine

! before doing any work on the cutting attachment.This continues to rotate even after the throttle has been released. Ensure that the cutting attachment has stopped completely and disconnect the HT lead from the spark plug before you start to work on it.

English 9

Image 9
Contents 327P4 327P5X-series Symbols KEY to SymbolsContents Dear Customer IntroductionWhat is what? What is WHAT?Personal protective equipment General Safety PrecautionsThrottle lockout Machine′s safety equipmentStop switch Vibration damping systemMuffler Quick release Balance Flex harness Cutting equipmentOnly use cutting equipment recommended by us Sharpening your chain and adjusting raker clearance Specification of bar and saw chainChain General Safety Precautions Tensioning the chain Lubricating cutting equipment Adjusting chain lubricationFilling with chain oil Checking chain lubricationWhat to do if lubrication does not work Checking wear on cutting equipment ChainChain drive sprocket May increase the risk of accidentsAdjusting the harness AssemblyFitting the cutting head Fitting the bar and chainFilling with oil AssemblyAssembling and dismantling the two-piece shaft Fitting the impact guardAssembly of the saw attachment Fuel safety Fuel HandlingFuel Mixing FuellingCheck before starting Starting and StoppingStarting and stopping StartingStopping Safety instructions while working Safety instructions regarding the surroundingsWorking Techniques General working instructionsBasic working techniques Safety instructions after completing workWithout having the cutting attachment in full view Carburettor MaintenanceCorrectly adjusted carburettor Fine adjustment of the idle speed TLow speed jet L High speed jet HCooling system MufflerSpark plug Is damaged it should be replacedTwo-piece shaft Cleaning the air filterAir filter Oiling the air filterMaintenance Daily Weekly Monthly Maintenance scheduleTechnical data Technical DataApproved accessories Art No Use with EC-declaration of conformity Applies to Europe onlyBar and chain combinations Page Page Page Page 1150991-26