WARNING: Stop engine. Make sure deck clutch switch is in the down (OFF) position. Remove ignition key. Place control levers in the brake position before leaving machine.
2.Park the unit on a flat surface.
3.Raise deck and place 3" tall spacer blocks under the edge of the deck - two in front on each side and two in back on each side. (FIG. 28). Remove the height adjusting stop
SPACER BLOCKS
FIG. 28
and let the deck down so it rests on the 3" spacer blocks. Make sure the deck is setting on all four blocks. Leave the height adjusting stop out of the square adjusting bar for now. The deck should be leveled before the height is set. (FIG. 29)
HEIGHT
STOP HANDLE
HEIGHT ADJUSTING
STOP
FIG. 29
4.Loosen the two nuts that hold the deck adjusting bar in position. (FIG. 30)
ADJUSTING BAR
NUTS
FIG. 30
333559 09/08 |