Husqvarna 355FRM Assembly, Assembling the handlebar and throttle, Transport position, handlebar

Page 15

ASSEMBLY

Assembling the handlebar and throttle

CAUTION! Some models have the throttle handle fitted at the factory.

Remove the screw at the rear of the throttle handle.

Slide the throttle handle onto the right side of the handlebar, (see diagram).

• Align the screw hole in the throttle handle with the hole

in the handlebar.

Tighten the knob.

Transport position, handlebar

The handlebar can easily be turned to fit along the shaft for easier transportation and storage.

Loosen the knob.Turn the handlebar clockwise so that the throttle handle rests against the engine.

Now twist the handlebar around the shaft. Tighten the knob.

Fit the transport guard to the cutting attachment.

Assembling the cutting equipment

• Refit the screw in the hole in the rear of the throttle

handle.

• Screw the screw through the handle and handlebar.

Tighten it.

• Unscrew the knob from the handlebar mounting.

• Position the handlebar as shown. Fit the mounting

components and tighten the knob lightly.

!

WARNING!

When fitting the cutting attachment it is extremely important that the raised section on the drive disc/support flange engages correctly in the centre hole of the cutting attachment. If the cutting attachment is fitted incorrectly it can result in serious and/or fatal personal injury.

Put on the harness and hang the machine from the support hook. Now make a final adjustment so that the machine is in a comfortable working position when it hangs from the harness.

!

WARNING! Never use a cutting

attachment without an approved guard.

 

See the chapter on Technical data. If an

 

incorrect or faulty guard is fitted this can

 

cause serious personal injury.

IMPORTANT! If a saw blade or grass blade are to be used the machine must be equipped with the correct handlebar, blade guard and harness.

English 15

Image 15
Contents 355FX 355FXT 355RX 355FRM Symbols KEY to SymbolsContents Dear Customer IntroductionWhat is what on the brush cutter? 355RX What is WHAT?What is what on the brush cutter? 355FX, 355FXT What is what on the brush cutter? 355FRM Personal protective equipment General Safety PrecautionsThrottle lockout Machine′s safety equipmentQuick release Stop switchCutting attachment guard Vibration damping systemLocking nut MufflerGeneral rules Cutting equipmentLocking screw Cutting equipmentTo straighten a twisted blade so that it Sharpening grass cutters and grass bladesSharpening the saw blade Bent, twisted, cracked, broken orTrimmer head Assembling the cutting equipment AssemblyAssembling the handlebar and throttle Transport position, handlebar355FX, 355FXT Fitting the blade guard and saw blade355RX Fitting other guards and cutting attachments Triobalance harness Adjusting the harness and brush cutterSafety release Adjusting the harnessGrass clearing Correct balanceFuel safety Fuel HandlingFuel Mixing FuellingCold engine Starting and StoppingCheck before starting Starting and stoppingHeated handles Warm engineStarting StoppingABC of clearing Basic safety rulesWorking Techniques General working instructionsWorking Techniques Forestry clearing using a saw blade Trimming Grass clearing using a grass bladeBrush cutting with a saw blade Grass trimming with a trimmer headShredding dense vegetation with a shredder blade CuttingSweeping Carburettor MaintenanceIs damaged it should be replaced MufflerCooling system Air filterBevel gear Drive shaftSpark plug Temperature 0C or colder Temperature -5C or colderWinter use Maintenance Maintenance Daily Weekly Monthly Maintenance scheduleTechnical data Technical DataCentre hole in blades/cutters, Ø 25,4 mm EC-declaration of conformity Applies to Europe only Trimmy SII Page Auto T45, T45x T55x Original instructions 1153302-26
Related manuals
Manual 92 pages 53.47 Kb