Husqvarna 355RX, 355FXT, 355FRM manual Fitting other guards and cutting attachments

Page 18

ASSEMBLY

Fit the drive disc (B) on the output shaft.

G

F

D

B

C

Turn the blade shaft until one of the holes in the drive disc aligns with the corresponding hole in the gear housing.

Insert the locking pin (C) in the hole to lock the shaft.

Place the shredder blade (D) and support flange (F) on the output shaft.

Fit the nut (G). The nut must be tightened to a torque of 35-50 Nm (3.5-5 kpm). Use the socket spanner in the tool kit. Hold the shaft of the spanner as close to the shredder blade guard as possible.

Fitting other guards and cutting attachments

Fit the trimmer guard/combination guard (A) intended for use with the trimmer head/plastic blades. Hang the trimmer guard/combination guard (A) on the two hooks on the plate holder (M). Bend the guard around the shaft and tighten it with the bolt (L) on the opposite side of the shaft. Use the locking pin (C). Place the

locking pin in the groove on the screw head and tighten. See diagram.

L

M

C

A

Fit the drive disc (B) on the output shaft.

H

P

B

C

Centre the metal cup (P) on the drive disc’s blade guide.

Turn the blade shaft until one of the holes in the drive disc aligns with the corresponding hole in the gear housing.

Insert the locking pin (C) in the hole to lock the shaft.

Screw on the trimmer head/plastic blades (H) in the opposite direction to the direction of rotation.

H

H

To dismantle, follow the instructions in the reverse order.

18 – English

Image 18
Contents 355FX 355FXT 355RX 355FRM KEY to Symbols SymbolsContents Introduction Dear CustomerWhat is WHAT? What is what on the brush cutter? 355RXWhat is what on the brush cutter? 355FX, 355FXT What is what on the brush cutter? 355FRM General Safety Precautions Personal protective equipmentMachine′s safety equipment Throttle lockoutVibration damping system Stop switchCutting attachment guard Quick releaseMuffler Locking nutCutting equipment Cutting equipmentLocking screw General rulesBent, twisted, cracked, broken or Sharpening grass cutters and grass bladesSharpening the saw blade To straighten a twisted blade so that itTrimmer head Transport position, handlebar AssemblyAssembling the handlebar and throttle Assembling the cutting equipmentFitting the blade guard and saw blade 355FX, 355FXT355RX Fitting other guards and cutting attachments Adjusting the harness Adjusting the harness and brush cutterSafety release Triobalance harnessCorrect balance Grass clearingFuel safety Fuel HandlingFuel Fuelling MixingStarting and stopping Starting and StoppingCheck before starting Cold engineStopping Warm engineStarting Heated handlesGeneral working instructions Basic safety rulesWorking Techniques ABC of clearingWorking Techniques Forestry clearing using a saw blade Grass trimming with a trimmer head Grass clearing using a grass bladeBrush cutting with a saw blade TrimmingShredding dense vegetation with a shredder blade CuttingSweeping Maintenance CarburettorAir filter MufflerCooling system Is damaged it should be replacedBevel gear Drive shaftSpark plug Temperature 0C or colder Temperature -5C or colderWinter use Maintenance Maintenance schedule Maintenance Daily Weekly MonthlyTechnical Data Technical dataCentre hole in blades/cutters, Ø 25,4 mm EC-declaration of conformity Applies to Europe only Trimmy SII Page Auto T45, T45x T55x Original instructions 1153302-26
Related manuals
Manual 92 pages 53.47 Kb