Husqvarna 355FRM Adjusting the harness and brush cutter, Triobalance harness, Safety release

Page 19

ASSEMBLY

Adjusting the harness and brush cutter

!	WARNING! When using a brush cutter it
!	must always be hooked securely to the
	harness. Otherwise you will be unable to
	control the brush cutter safely and this
	can result in injury to yourself or others.
	Never use a harness with a defective
	quick release.

Triobalance harness

Safety release

Push down the red release lever to release the machine from the harness.

Adjusting the harness

1 Tighten the hip strap so that it sits securely.

2Tighten the chest strap under your left arm so that it ﬁts closely around your body.

3Adjust the shoulder strap to distribute the load evenly across your shoulders. Press downwards on the suspension hook to load the harness.

4Adjust the height of the hanging ring as per the instructions. (Forest clearing)

5If you need to lower the suspension hook, for trimming for example, move the suspension strap (A) to the lower mounting point on the backplate.

6The elastic strap (B) can be tightened to transfer more load from the shoulder straps to the hip strap.

A

B

Correct height

1Forestry clearing

The machine should be supported in a harness when forestry clearing so that the cutting equipment is angled slightly forwards in relation to the ground.

English – 19

Image 19

Contents 355FX 355FXT 355RX 355FRM Symbols KEY to SymbolsContents Dear Customer IntroductionWhat is what on the brush cutter? 355RX What is WHAT?What is what on the brush cutter? 355FX, 355FXT What is what on the brush cutter? 355FRM Personal protective equipment General Safety PrecautionsThrottle lockout Machine′s safety equipmentQuick release Stop switchCutting attachment guard Vibration damping systemLocking nut MufﬂerGeneral rules Cutting equipmentLocking screw Cutting equipmentTo straighten a twisted blade so that it Sharpening grass cutters and grass bladesSharpening the saw blade Bent, twisted, cracked, broken orTrimmer head Assembling the cutting equipment AssemblyAssembling the handlebar and throttle Transport position, handlebar355FX, 355FXT Fitting the blade guard and saw blade355RX Fitting other guards and cutting attachments Triobalance harness Adjusting the harness and brush cutterSafety release Adjusting the harnessGrass clearing Correct balanceFuel Handling Fuel safetyFuel Mixing FuellingCold engine Starting and StoppingCheck before starting Starting and stoppingHeated handles Warm engineStarting StoppingABC of clearing Basic safety rulesWorking Techniques General working instructionsWorking Techniques Forestry clearing using a saw blade Trimming Grass clearing using a grass bladeBrush cutting with a saw blade Grass trimming with a trimmer headCutting Shredding dense vegetation with a shredder bladeSweeping Carburettor MaintenanceIs damaged it should be replaced MufﬂerCooling system Air ﬁlterDrive shaft Bevel gearSpark plug Temperature -5C or colder Temperature 0C or colderWinter use Maintenance Maintenance Daily Weekly Monthly Maintenance scheduleTechnical data Technical DataCentre hole in blades/cutters, Ø 25,4 mm EC-declaration of conformity Applies to Europe only Trimmy SII Page Auto T45, T45x T55x Original instructions 1153302-26

Related manuals

Manual 92 pages 53.47 Kb