Husqvarna 355RX, 355FXT, 355FRM manual Maintenance

Page 34

MAINTENANCE

particular attention that the opening on the air duct is positioned in the centre of the hole in the air ﬁlter holder.

IMPORTANT! If the temperature rises above -5°C or 0°C respectively the machine MUST be restored to its normal set-up. Otherwise there is a risk of overheating, which can cause severe engine damage.

IMPORTANT! Any maintenance other than that described in this manual must be carried out by your servicing dealer (retailer).

34 – English

Image 34

Contents 355FX 355FXT 355RX 355FRM KEY to Symbols SymbolsContents Introduction Dear CustomerWhat is WHAT? What is what on the brush cutter? 355RXWhat is what on the brush cutter? 355FX, 355FXT What is what on the brush cutter? 355FRM General Safety Precautions Personal protective equipmentMachine′s safety equipment Throttle lockoutVibration damping system Stop switchCutting attachment guard Quick releaseMufﬂer Locking nutCutting equipment Cutting equipmentLocking screw General rulesBent, twisted, cracked, broken or Sharpening grass cutters and grass bladesSharpening the saw blade To straighten a twisted blade so that itTrimmer head Transport position, handlebar AssemblyAssembling the handlebar and throttle Assembling the cutting equipmentFitting the blade guard and saw blade 355FX, 355FXT355RX Fitting other guards and cutting attachments Adjusting the harness Adjusting the harness and brush cutterSafety release Triobalance harnessCorrect balance Grass clearingFuel Handling Fuel safetyFuel Fuelling MixingStarting and stopping Starting and StoppingCheck before starting Cold engineStopping Warm engineStarting Heated handlesGeneral working instructions Basic safety rulesWorking Techniques ABC of clearingWorking Techniques Forestry clearing using a saw blade Grass trimming with a trimmer head Grass clearing using a grass bladeBrush cutting with a saw blade TrimmingCutting Shredding dense vegetation with a shredder bladeSweeping Maintenance CarburettorAir ﬁlter MufﬂerCooling system Is damaged it should be replacedDrive shaft Bevel gearSpark plug Temperature -5C or colder Temperature 0C or colderWinter use Maintenance Maintenance schedule Maintenance Daily Weekly MonthlyTechnical Data Technical dataCentre hole in blades/cutters, Ø 25,4 mm EC-declaration of conformity Applies to Europe only Trimmy SII Page Auto T45, T45x T55x Original instructions 1153302-26

Related manuals

Manual 92 pages 53.47 Kb