Husqvarna 143R-II manual Fuelling, Mixing, WARNING! Taking the following, Fuel Handling

Page 17
Mixing

FUEL HANDLING

Mixing

Always mix the petrol and oil in a clean container intended for fuel.

Always start by filling half the amount of the petrol to be used. Then add the entire amount of oil. Mix (shake) the fuel mixture. Add the remaining amount of petrol.

Mix (shake) the fuel mixture thoroughly before filling the machine’s fuel tank.

Do not mix more than one month’s supply of fuel at a time.

If the machine is not used for some time the fuel tank should be emptied and cleaned.

Fuelling

WARNING! Taking the following

!precautions, will lessen the risk of fire:

Do not smoke or place hot objects near fuel.

Always shut off the engine before refuelling.

Always stop the engine and let it cool for a few minutes before refuelling.

When refuelling, open the fuel cap slowly so that any excess pressure is released gently.

Tighten the fuel cap carefully after refuelling.

Always move the machine away from the refuelling area before starting.

Always use a fuel container with an anti-spill valve.

Clean the area around the fuel cap. Contamination in the tank can cause operating problems.

Ensure that the fuel is well mixed by shaking the container before filling the tank.

English 17

Image 17
Contents Page Symbols KEY TO SYMBOLSThe operator of the machine must ensure, while working, that noContents CONTENTSKEY TO SYMBOLS CONTENTSINTRODUCTION What is what on the brushcutter? WHAT IS WHAT?WARNING! Listen out for warning signals GENERAL SAFETY PRECAUTIONSPersonal protective equipment WARNING! The ignition system of thisWARNING! Never use a machine with Machine′s safety equipmentThrottle lockout Cutting attachment guard Stop switchVibration damping system WARNING! Never use a cuttingMuffler Quick releaseLocking nut WARNING! The inside of the mufflerCutting equipment WARNING! Using an incorrect cuttingCutting equipment Sharpening grass cutters and grass bladesTrimmer head Connecting throttle cable and stop switch wires ASSEMBLYFitting the main body Assembling the handlebar and throttle1-2mm Fitting blades and trimmer headsFitting the trimmer guard and trimmer head Fitting the guard extensionG E F D B C H L M C BA AM LWARNING! When using a clearing saw it Adjusting the harness and clearing sawFitting the transport guard Standard harnessWARNING! Take care when handling fuel Fuel safetyFUEL HANDLING FuelFuelling precautions, will lessen the risk of fireMixing WARNING! Taking the followingCheck before starting STARTING AND STOPPINGStarting and stopping Startingstarter cord around your hand WARNING! When the engine is startedStopping WORKING TECHNIQUES Basic safety rulesGeneral working instructions WARNING! Neither the operator of theBasic working techniques Grass clearing using a grass bladeGrass trimming with a trimmer head WARNING! Sometimes branches orSweeping CuttingAdjusting the idle speed T MAINTENANCECarburettor MufflerAir filter Cleaning the air filterFuel filter Bevel gearMaintenance Maintenance schedulemaintenance DailyTechnical data TECHNICAL DATATechnical data WeightEC-declarationof conformity Approved accessoriesApplies to Europe only TypePage Clic 8,5 m 28 10 cm 4,2 m15 cm 2,4-2,7 mm4,25 m 2,4-2,7mm095-.106 8,5 m 28 10 cm 4,3 m T35, T35x2,7-3,3 mm T45, T45x10 m 32 10 cm 4,3 m A 2,7 - 4,0 mm T55xB 8 m / 26’ C 15 cm095-.130 Trimmy SII7,0 m 12 cm