ASSEMBLY
Fitting the main body
Connect the engine (A) to the tube (B) with four screws
(C).
Assembling the handlebar and throttle
•Fit the handlebar in the handlebar clamp on the shaft using four screws.
•Attach the cabling to the shaft with two cabling holders.
Make sure that the suspension ring and the handlebar clamp are located in the area indicated by the arrow
labels. If they are moved outside of this area, it can cause the machine to be imbalanced, which can be dangerous.
A
(A) Arrow labels
Connecting throttle cable and stop switch wires
1Remove the air filter cover.
2Insert the throttle cable (A) to the end of the adjuster
(B).
3Position the slotted fitting (C) on the carburettor so the recessed hole (D) for the cable lug (E) is away from the cable adjuster sleeve.
4Rotate the carburettor throttle cam and slip the throttle cable through the slot in the slotted fitting, making sure the cable lug drops into the recessed hole.
5Operate the throttle trigger a few times to make sure that it works correctly.
6Adjust the cable adjuster sleeve so the stop on the carburettor throttle cam just contacts the throttle stop
12 – English