UNPACKING
1.Locate the parts carton and set aside for later use.
2.Cut wire ties holding generator to pallet and remove protective wrapping.
3.Remove all packaging, leaving generator on pallet.
IMPORTANT: DO NOT remove generator from pallet.
4.Discard all packaging.
ASSEMBLE WHEEL KIT
Tools needed:
2 - 2x4 at least 30” long
1 - 1/2" socket
1 - 1/2" open end wrench
1 - hammer
1 - pliers
Kit Contains:
2 - | Handles |
2 - | Wheels |
1 - | Axle |
2 - | Foot Brackets |
Protective
Wrapping
Wire Tie
Parts bag contains:
2 - Handle Grips
6 - Screws,
1 - Cotter Pin
1 - Flat Steel Washer
2 - Axle Spacers
6 - Cap Screw
8 - Flange Nuts
2 - Wheel Brackets
1 - 5/8" Axle Cap
2 - Rubber Bumpers
2 - Kep Nuts,
2 - Handle Brackets
2 - Snap Buttons
1.Lift the gas tank end of generator and slide 2x4 between generator and pallet as shown.
The generator is too heavy to be lifted by one person. Obtain as-
sistance from others before lifting.
Gas Tank
2x4
NOTE: Photos are shown for clarity only, DO NOT tilt generator onto it's end.
2.Attach rubber bumpers (10) to foot brackets (1) using screws (9) and keps nuts. Tighten securely.
3.Attach foot bracket assembly (1) to generator frame with screws (9). Tighten screws securely. NOTE: These screws are
9
10
1
9
9- ENG | A01296 |