Poulan PD25PH48STB owner manual To Replace Headlight Bulb, Interlocks and Relays, To Replace Fuse

Page 25

SERVICE AND ADJUSTMENTS

TO REPLACE HEADLIGHT BULB

•Raise hood.

•Pull bulb holder out of the hole in the backside of the grill.

•Replace bulb in holder and push bulb holder securely back into the hole in the backside of the grill.

•Close hood.

INTERLOCKS AND RELAYS

Loose or damaged wiring may cause your tractor to run poorly, stop running, or prevent it from starting.

•Check wiring. See electrical wiring diagram in the Repair Parts section.

TO REPLACE FUSE

Replace with 20 amp automotive-type plug-in fuse. The fuse holder is located behind the dash.

TO REMOVE HOOD AND GRILL ASSEMBLY (See Fig. 31)

•Raise hood.

•Unsnap headlight wire connector.

•Stand in front of tractor. Grasp hood at sides, tilt toward engine and lift off of tractor.

•To replace, reverse above procedures.

HOOD

HEADLIGHT WIRE CONNECTOR

02141

FIG. 31

ENGINE

TO ADJUST THROTTLE CONTROL CABLE (See Fig. 32)

The throttle control has been preset at the factory and adjustment should not be necessary. Check adjustment as described below before loosening cable. If adjustment is necessary, proceed as follows:

•With engine not running, move throttle control lever to fast position.

•Check that swivel is against stop. If it is not, loosen cable clamp screw and pull cable back until swivel is against stop. Tighten cable clamp screw securely.

TO ADJUST CHOKE CONTROL (See Fig. 33)

The choke control has been preset at the factory and ad- justment should not be necessary. Check adjustment as described below before loosening cable. If adjustment is necessary, proceed as follows:

•With engine not running, move choke control (located on dash panel) to full choke position.

•Loosen knob and remove cover assembly from air cleaner.

•Choke should be closed.If it is not, loosen casing clamp screw and move choke cable until choke is completely closed. Tighten casing clamp screw securely.

•Replace air cleaner cover assembly and tighten knob.

TO ADJUST CARBURETOR

Your carburetor is not adjustable. If your engine does not operate properly due to suspected carburetor problems, take your tractor to an authorized service center for repair and/or adjustment.

High speed stop is factory adjusted. Do not adjust - dam- age may result.

IMPORTANT:NEVERTAMPERWITHTHEENGINEGOVERNOR, WHICH IS FACTORY SET FOR PROPER ENGINE SPEED. OVERSPEEDING THE ENGINE ABOVE THE FACTORY HIGH SPEED SETTING CAN BE DANGEROUS. IF YOU THINK THE ENGINE-GOVERNED HIGH SPEED NEEDS ADJUSTING, CONTACTYOUR NEAREST AUTHORIZED SERVICE CENTER/ DEPARTMENT, WHICH HAS PROPER EQUIPMENT AND EXPERIENCE TO MAKE ANY NECESSARY ADJUSTMENTS.

 

STOP

02119

 

SWIVEL

CLAMP SCREW

FIG. 32

CLAMP SCREW

FIG. 33

25

Page 24 Page 26
Image 25
Page 24 Page 26
Contents PD25PH48STB Safety Rules Safety Rules Table of Contents Unassembled Parts Tools Required for Assembly AssemblyHOW to SET UP Your Tractor To Remove Tractor from CartonAssemble Gauge Wheels to Mower Deck See Fig Install Seat See FigTo Attach Nose Roller See Fig Install Mower and Drive Belt See FigsCheck Mower Levelness Check Tire PressureCheck for Proper Position of ALL Belts Check Brake SystemOperation Know Your Tractor HOW to USE Your Tractor To Operate Mower See Fig To Adjust Gauge Wheels See FigTo Operate on Hills To Transport See FigsTowing Carts and Other ATTACH- Ments Before Starting the EngineCheck Engine OIL Level ADD GasolineMowing Tips Purge TransmissionAutomatic Transmission Warm UP NingLubrication Chart MaintenanceGeneral Recommendations Before Each USETractor Engine Clean AIR INTAKE/COOLING Areas CleaningMuffler Spark PlugsTo Install Mower Service and AdjustmentsTo Remove Mower See Fig FRONT-TO-BACK Adjustment See Figs To Level Mower HousingTo Replace Mower Blade Secondary To Replace Mower Drive BeltTransmission REMOVAL/REPLACEMENT To Check and Adjust Brake See FigTo Replace Motion Drive Belt See Fig To Start Engine with a Weak Battery See Fig To Adjust Steering Wheel ALIGN- MentReplacing Battery See Fig Front Wheel TOE-IN/CAMBERTo Replace Headlight Bulb To Adjust CarburetorInterlocks and Relays To Replace FuseOther StorageFuel System Engine OILProblem Cause Correction Troubleshooting PointsWith attachment clutch Tractor Model Number PD25PH48STB SchematicElectrical 188031 KEY Part DescriptionChassis and Enclosures 186689 187495Drive Tractor Model Number PD25PH48STB17000612 17060516Steering Assembly 72110618 184704X428 Wheel Steering 184706 Axle188967 Optional Equipment EngineSpark Arrester KEY Part NO. NO. Description 1712 Seat AssemblySeat Wheels & Tires DecalsMower Lift 125631X 178981124526X Mower Deck KEY Part Description Limited Warranty Suggested Guide for Sighting Slopes for Safe Operation Parts and Service

PD25PH48STB specifications

The Poulan PD25PH48STB is a versatile lawn tractor designed to deliver performance and comfort for homeowners looking to maintain their lawns with ease. It is particularly well-suited for those with medium to large yards, providing the necessary power and features to make lawn care more efficient.

One of the standout features of the Poulan PD25PH48STB is its robust 48-inch cutting deck, which allows for a wider cutting path. This is beneficial for covering more ground in less time, reducing the overall time spent mowing the lawn. The deck is designed with a durable steel construction that ensures longevity and resilience against various elements.

The mower is powered by a reliable 25 horsepower Briggs & Stratton engine. This engine combines power with fuel efficiency, offering excellent performance to tackle even the toughest grass conditions. The electric start feature adds convenience, allowing users to start the engine with the turn of a key rather than the traditional method of pulling a cord.

Another notable characteristic of the PD25PH48STB is its six-speed transmission, which provides excellent control and adaptability depending on the mowing conditions. This allows users to adjust their speed based on their preference or the terrain, whether it’s flat or hilly.

The tractor also features an ergonomic seat design, ensuring comfort during extended mowing sessions. The adjustable seat makes it easy to find the perfect riding position, while the easy-to-reach controls enhance the overall user experience. To further enhance comfort, the PD25PH48STB comes equipped with a deck wash port that simplifies cleaning, allowing users to maintain the mower with minimal effort.

For those concerned about safety, this lawn tractor includes an automatic safety shut-off feature that engages when the operator leaves the seat, providing peace of mind while mowing. Additionally, the tight turning radius allows for greater maneuverability, making it easier to navigate around trees, flower beds, and other obstacles in the yard.

Overall, the Poulan PD25PH48STB is an exceptional choice for homeowners looking for a dependable, efficient, and comfortable lawn mowing solution. With its powerful engine, generous cutting deck, user-friendly features, and safety mechanisms, it stands out as a top contender in the lawn tractor market.
Top Page Image Contents