Poulan PD25PH48STB owner manual To Adjust Steering Wheel ALIGN- Ment, Front Wheel TOE-IN/CAMBER

Page 24

SERVICE AND ADJUSTMENTS

TO ADJUST STEERING WHEEL ALIGN- MENT

If steering wheel crossbars are not horizontal (left to right) when wheels are positioned straight forward, remove steer- ing wheel and reassemble per instructions in the Assembly section of this manual.

FRONT WHEEL TOE-IN/CAMBER

The front wheel toe-in and camber are not adjustable on your tractor. If damage has occurred to affect the front wheel toe-in or camber, contact your nearest authorized service center/department.

TO REMOVE WHEEL FOR REPAIRS (See Fig. 28)

•Block up axle securely.

•Remove axle cover, retaining ring and washers to allow wheel removal (rear wheel contains a square key - Do not lose).

•Repair tire and reassemble.

•On rear wheels only: align grooves in rear wheel hub and axle. Insert square key.

•Replace washers and snap retaining ring securely in axle groove.

•Replace axle cover.

NOTE: To seal tire punctures and prevent flat tires due to slow leaks, tire sealant may be purchased from your local parts dealer. Tire sealant also prevents tire dry rot and corrosion.

WASHERS

RETAINING

RING

AXLE

COVER

00663

SQUARE KEY (REAR

WHEEL ONLY)

FIG. 28

TO START ENGINE WITH A WEAK BATTERY (See Fig. 29)

WARNING: Lead-acid batteries gen- erate explosive gases. Keep sparks, flame and smoking materials away from batteries. Always wear eye protection

TO ATTACH JUMPER CABLES -

•Connect one end of the RED cable to the POSITIVE

(+)terminal of each battery(A-B), taking care not to short against tractor chassis.

•Connect one end of the BLACK cable to the NEGATIVE (-) terminal (C) of fully charged battery.

•Connect the other end of the BLACK cable (D) to good chassis ground, away from fuel tank and battery.

TO REMOVE CABLES, REVERSE ORDER -

•BLACK cable first from chassis and then from the fully charged battery.

•RED cable last from both batteries.

02614

WEAK OR DEAD

FULLY CHARGED

BATTERY

BATTERY

FIG. 29

REPLACING BATTERY (See Fig. 30)

CAUTION: Do not short battery termi- nals by allowing a wrench or any other object to contact both terminals at the same time. Before connecting battery, remove metal bracelets, wristwatch bands,rings,etc.

Positive terminal must be connected first to prevent sparking from accidental grounding.

•Lift hood to raised position.

•Remove terminal guard.

•Disconnect BLACK battery cable then RED battery cable and carefully remove battery from tractor.

•Install new battery with terminals in same position as old battery.

•Reinstall terminal guard.

•First connect RED battery cable to positive (+) battery terminal with hex bolt and keps nut as shown. Tighten securely.

•Connect BLACK grounding cable to negative (-) battery terminal with remaining hex bolt and keps nut. Tighten securely

•Close terminal access doors.

•Close hood.

when around batteries.

If your battery is too weak to start the engine, it should be recharged. (See "BATTERY" in the Maintenance section of this manual).

If “jumper cables” are used for emergency starting, follow this procedure:

IMPORTANT: YOUR TRACTOR IS EQUIPPED WITH A 12 VOLT SYSTEM. THE OTHER VEHICLE MUST ALSO BE A 12 VOLT SYSTEM. DO NOT USE YOUR TRACTOR BATTERY TO START

KEPS NUT

TERMINAL

ACCESS

DOOR

TERMINAL

02179

GUARD

 

HEX

BOLT

POSITIVE (RED)

CABLE

NEGATIVE (BLACK)

CABLE

OTHER VEHICLES.

FIG. 30

24

Page 23 Page 25
Image 24
Page 23 Page 25
Contents PD25PH48STB Safety Rules Safety Rules Table of Contents Unassembled Parts Assembly Tools Required for AssemblyHOW to SET UP Your Tractor To Remove Tractor from CartonInstall Seat See Fig Assemble Gauge Wheels to Mower Deck See FigInstall Mower and Drive Belt See Figs To Attach Nose Roller See FigCheck Tire Pressure Check Mower LevelnessCheck for Proper Position of ALL Belts Check Brake SystemOperation Know Your Tractor HOW to USE Your Tractor To Adjust Gauge Wheels See Fig To Operate Mower See FigTo Operate on Hills To Transport See FigsBefore Starting the Engine Towing Carts and Other ATTACH- MentsCheck Engine OIL Level ADD GasolinePurge Transmission Mowing TipsAutomatic Transmission Warm UP NingMaintenance Lubrication ChartGeneral Recommendations Before Each USETractor Engine Cleaning Clean AIR INTAKE/COOLING AreasMuffler Spark PlugsService and Adjustments To Install MowerTo Remove Mower See Fig To Level Mower Housing FRONT-TO-BACK Adjustment See FigsTo Replace Mower Drive Belt To Replace Mower Blade SecondaryTo Check and Adjust Brake See Fig Transmission REMOVAL/REPLACEMENTTo Replace Motion Drive Belt See Fig To Adjust Steering Wheel ALIGN- Ment To Start Engine with a Weak Battery See FigReplacing Battery See Fig Front Wheel TOE-IN/CAMBERTo Adjust Carburetor To Replace Headlight BulbInterlocks and Relays To Replace FuseStorage OtherFuel System Engine OILTroubleshooting Points Problem Cause CorrectionWith attachment clutch Schematic Tractor Model Number PD25PH48STBElectrical KEY Part Description 188031Chassis and Enclosures 187495 186689Tractor Model Number PD25PH48STB Drive17060516 17000612Steering Assembly 184704X428 Wheel Steering 184706 Axle 72110618188967 Engine Optional EquipmentSpark Arrester KEY Part NO. NO. Description Seat Assembly 1712Seat Decals Wheels & TiresMower Lift 178981 125631X124526X Mower Deck KEY Part Description Limited Warranty Suggested Guide for Sighting Slopes for Safe Operation Parts and Service

PD25PH48STB specifications

The Poulan PD25PH48STB is a versatile lawn tractor designed to deliver performance and comfort for homeowners looking to maintain their lawns with ease. It is particularly well-suited for those with medium to large yards, providing the necessary power and features to make lawn care more efficient.

One of the standout features of the Poulan PD25PH48STB is its robust 48-inch cutting deck, which allows for a wider cutting path. This is beneficial for covering more ground in less time, reducing the overall time spent mowing the lawn. The deck is designed with a durable steel construction that ensures longevity and resilience against various elements.

The mower is powered by a reliable 25 horsepower Briggs & Stratton engine. This engine combines power with fuel efficiency, offering excellent performance to tackle even the toughest grass conditions. The electric start feature adds convenience, allowing users to start the engine with the turn of a key rather than the traditional method of pulling a cord.

Another notable characteristic of the PD25PH48STB is its six-speed transmission, which provides excellent control and adaptability depending on the mowing conditions. This allows users to adjust their speed based on their preference or the terrain, whether it’s flat or hilly.

The tractor also features an ergonomic seat design, ensuring comfort during extended mowing sessions. The adjustable seat makes it easy to find the perfect riding position, while the easy-to-reach controls enhance the overall user experience. To further enhance comfort, the PD25PH48STB comes equipped with a deck wash port that simplifies cleaning, allowing users to maintain the mower with minimal effort.

For those concerned about safety, this lawn tractor includes an automatic safety shut-off feature that engages when the operator leaves the seat, providing peace of mind while mowing. Additionally, the tight turning radius allows for greater maneuverability, making it easier to navigate around trees, flower beds, and other obstacles in the yard.

Overall, the Poulan PD25PH48STB is an exceptional choice for homeowners looking for a dependable, efficient, and comfortable lawn mowing solution. With its powerful engine, generous cutting deck, user-friendly features, and safety mechanisms, it stands out as a top contender in the lawn tractor market.
Top Page Image Contents