MUFFLER
Inspect and replace corroded muffler and spark arrester (if equipped) as it could cre- ate a fire hazard and/or damage.
SPARK PLUG(S)
Replace spark plug(s) at the beginning of each mowing season or after every 100 hours of operation, whichever occurs first. Spark plug type and gap setting are shown in “PRODUCT SPECIFICATIONS” section of this manual.
IN-LINE FUEL FILTER
The fuel filter should be replaced once each season. If fuel filter becomes clogged, obstructing fuel flow to carbu- retor, replacement is required.
1.With engine cool, remove filter and plug fuel line sections.
2.Place new fuel filter in position in fuel line with arrow pointing towards carburetor.
3.Be sure there are no fuel line leaks and clamps are properly positioned.
4. Immediately wipe up any spilled gasoline.
Clamp | Clamp |
| |
Fuel Filter | 00667 |
CLEANING
•Clean engine, battery, seat, finish, etc. of all foreign matter.
•Keep finished surfaces and wheels free of all gasoline, oil, etc.
•Protect painted surfaces with auto- motive type wax.
We do not recommend using a garden hose or pressure washer to clean your tractor unless the engine and transmis- sion are covered to keep water out. Water in engine or transmission will shorten the useful life of your tractor. Use compressed air or a leaf blower to remove grass, leaves and trash from tractor and mower.
SERVICE AND ADJUSTMENTS
WARNING: TO AVOID SERIOUS INJURY, BEFORE PERFORMING ANY SER- VICE OR ADJUSTMENTS:
1.Depress clutch/brake pedal fully and set parking brake.
2.Place motion control lever in neutral (N) position.
3.Place attachment clutch in “DISENGAGED” position.
4.Turn ignition key to “STOP” and remove key.
5.Make sure the blades and all moving parts have completely stopped.
6.Disconnect spark plug wire from spark plug and place wire where it cannot come in contact with plug.
TRACTOR
TO REMOVE MOWER
Mower will be easier to remove from the right side of tractor.
1.Place attachment clutch switch in “DIS- ENGAGED” position.
2.Move attachment lift lever forward to lower mower to its lowest position.
Retainer
Spring
Bar
Retainer Spring
3.Roll belt off electric clutch pulley.
4.Disconnect
5.Disconnect suspension arms from rear deck brackets by removing retainer springs.
Electric Clutch Pulley
Front Link
Retainer Springs
(Both Sides)
Deflector Shield
20 | 01698 |
|