27
Operations
5
Projectorplacementangleadjustments
The placement angle and the height of the projected image can be adjusted by the foot
adjuster.

j Lift up the front of the projector to

the desired angle, then press the

foot adjuster release button.

The foot adjuster extends. Release the but-
ton to lock the position.

k To adjust the horizontal angle, use

the tilt adjuster.

To stow the foot adjuster, hold up the projector
while pressing the foot adjuster release button,
then slowly lower the projector.
6
Adjusting the screen size and focus

j

Usethezoomingringtoadjustthescreensize.

k Use the focusing ring to adjust the focus.

7
AdjustingthevolumewithVOL+/-buttons
The speaker volume can be adjusted when an audio signal is being input.

Notes

•Lampcharacteristicsmayrarelycausethebrightnesstouctuateslightly.
•Alampisconsumableitem.Ifusedforextendedperiods,imageswillappeardark,and
the lamp could burn out. This is characteristic of a lamp, and is not malfunction. (The
lifetime of the lamp depends on conditions of use.)
•TheDLP® chip is made using extremely advanced technology. There may be black spots
(pixels that do not light) or bright spots (pixels that are constantly lit) on the panel. These
are intrinsic characteristics of the technology and are not malfunctions.
•AlthoughthisprojectorsupportsawiderangeofRGBsignals
p.43
, any resolutions not
supported by this projector (XGA) will be expanded or shrunk, which will affect image
quality slightly. To view high-quality images, set the computer’s external output to XGA.
•WithsomemodelsofcomputerhavingLCDdisplaysorthelike,displayingimages
simultaneously on the projector and the monitor’s display may prevent the images from
displaying properly. If this happens, turn off the computer’s LCD display. For information
on how to turn off the LCD display, see the computer’s owner’s manual.
•Ifnosignalisbeinginputfromtheconnectedequipmentorsignalinputisstoppedwhile
projecting, the “No signal” message will appear.
•Ifasignalnotsupportedbytheprojectorisinput,the“Unsupported signal” message
will appear.
•Ifanunavailableoperationbuttonispressed,the icon will appear.
2
1
2
1