GB
hot, its display will show an H, otherwise it will show a 0. Touch any sensor to switch off the beeping signal.
Changing the programmed time
The time that you have set can be chan- ged. To do so, touch the clock sensor 
(7)until the display of the corresponding hotplate (10) flash on.
Then you will be able to read and change te time.
Disconnecting the clock
If you wish to stop the clock before the pro- grammed time has elapsed:
1 Touch the clock sensor 
(7) so many times as it's needed, until the display of the corresponding hotplate (10) flash on, or just select the hotplate and touch the clock sensor 
(7).
2 Make sure the decimal point is light (11) in the indicator (8).
3 Use sensor 
(4) to reduce the time down to 00. The clock is cancelled.
Switching off quickly
Repeat the steps1 and 2.
3 Touching the 
and 
sensors (5 and
4)at the same time cancels the remai- ning time.
The clock as a countdown timer
Whenever the clock is not being used in conjunction with a cooking area, it can be used as a countdown timer.
SWITCHING THE COUNTDOWN TIMER ON
When the appliance is switched off.
1 Touch the timer button 
(7) as many times as necessary, until the correspon- ding countdown timer light (13), located in the centre, below the timer displays (8), turns on.
2 Make sure the decimal point is light (11) in the indicator (8).
3 Use sensors 
and 
(4/5) to set the time.
After the set time has elapsed, a series of beeps will be emitted for several seconds. To turn off these beeps touch any of the buttons, except the On/Off button 
(1).
Adjusting the Programmed Time
To adjust the programmed time, hold down the timer button 
(7) until the countdown timer light (13) flashes. You can then see the time and adjust it.
DISCONNECTING THE COUNTDOWN TIMER
If you wish to stop the countdown timer before the programmed time has elapsed:
1 Touch the timer button 
(7) as many times as necessary, until the correspon- ding countdown timer light (13) turns on, located centrally, below the timer dis- plays (8).
2 Make sure the decimal point is light (11) in the indicator (8).
3 Use sensor 
(4) to reduce the time to 00. The clock is cancelled.
24
