GB
| fig. 2 |
Fitting holes | |
|
|
L | W |
|
Model ...604:
|
|
|
|
| . |
|
|
|
| x | |
|
|
| a |
| |
|
| m |
|
| |
| 5 |
|
|
| |
7 |
|
|
|
| |
5 |
|
|
|
|
|
L | W |
|
The dimensions L and W are shown in the table "Dimensions and characteristics" of the Technical Information section.
If a fan oven is being installed, please remember that this hob has only been cer- tified to work with TEKA brand ovens.
Leave a space in the front of the cabinet so that the hot air can ventilate properly. The opening should be at least 5 mm high. The longitude should be the width of the cabinet.
An opening of 20 mm should be made in the back part of the cabinet in order to allow cold air to enter (see figure 1).
INSTALLING THE AIR NOZZLE (MODELS …604)
braced to the back of the hob.
fig. 3
Warnings:
When hobs are handled before being installed, care should be taken in case there is any protruding part or sharp edge which could cause injury.
When installing units or applian- ces above the hob, the hob should be protected by a board so that the glass cannot be damaged by accidental blows or heavy weights.
The glues used in manufacturing the kitchen unit and in the adhesive on the decorative laminate of the worktop surface should be made to tolerate tem- peratures of up to 100ºC.
TEKA assumes no responsibility for any malfunction or damage caused by faulty installation.
PLEASE REMEMBER THAT THE GUA- RANTEE DOES NOT COVER THE GLASS IF IT SUFFERS A VIOLENT BLOW OR IF IT IS USED IMPROPERLY.
Fastening the hob
Place the nozzle over the air vent with the air valve toward the front part of the hob and use the screws provided to screw the nozzle. By doing so, the air nozzle will stay
When the gap has been properly sized, the sealing washer should be put on the lower face of the glass. Silicone should not be applied between the glass and the unit
12
