GB
10Lock activated indicator light (model …604).
11Decimal point in power indicators and time indicator.
-Shines (on): Chosen induction element (ready to be used).
-Doesn't shine (off): Induction element locked (cannot be used).
12Keep warm sensor (models …622). N.B.: * Only visible when in operation.
The sensors marked on the control panel are used for control purposes.
There is no need to exert pressure on the glass - you enable the function you requi- re simply by touching the sensor with your finger.
Each action is confirmed by a beep.
SWITCHING THE APPLIANCE ON
1 Touch the On sensor 
(1) for at least one second.
The touch control is enabled, 0 appears on all the power displays (3) and the decimal point (11) flashes on and off to indicate that no cooking area is selected at that time. If the cooking area is hot, the corres- ponding display will alternate between a H and an 0.
If the safety lock function is enabled, the cooking area displays will show the letter L. If the cooking area is still emitting resi- dual heat, the corresponding display will alternate between the letters L and H.
The following action must be carried out within 20 seconds or the touch control will automatically switch off.
When the touch control is enabled, it can be disconnected at any time by touching
the sensor 
(1), even if the lock is on
(safety lock function enabled). The sensor
(1) always has priority for disconnec- ting touch control.
SWITCHING THE HOTPLATES ON
Once the touch control has been enabled
using the 
sensor (1), the hotplates required can be switched on.
1 Select the hotplate by touching the corresponding sensor 
(2). N.B.: the sensor has a double function: the first press selects the hotplate and the follo- wing presses increase the power.
A 0 appears on the corresponding power display and the decimal point (11) lights up to show that the hotplate is selected.
Before using a hotplate, first check that it is selected, i.e. that the correspon- ding decimal point (11) is showing.
2 Using sensors 
or 
(2/4), select the required power level (from 1 to 9).
The 
and 
sensors are repetitive, so if you keep your finger on them they go up or down continuously.
After 10 seconds have elapsed from the last time the 
key was pressed, the decimal point goes out and the hotplate is locked.
Only one hotplate can be enabled at a time, which means that only one decimal point (11) will be lit up.
To turn a hotplate up to full power quickly: Select the hotplate and touch the sensor 
(4) once. The hotplate will be set to its maximum power (level 9).
SWITCHING THE HOTPLATE OFF
1 The hotplate must have already been
16
