selected. The corresponding decimal point (11) must be lit.
2 Use sensor 
(4) to decrease the power to level 0. The hotplate will automatically switch off.
To turn it off quickly: Whatever the power level, the hotplate is turned off
immediately if you touch the 
and sensors (2/4) simultaneously.
If all the cooking areas are positioned at 0, all the display points will flash.
When a hotplate is switched off, an H will appear on the corresponding power dis- play if the surface of the glass in the corresponding cooking area reaches a temperature at which there is a risk of bur- ning. When the temperature drops, the display will go out (if the hob is disconnec- ted), or a 0 is displayed if the hob is still on.
SWITCHING THE APPLIANCE OFF
The appliance may be switched off at any time by touching the general on / off sen- sor 
(1). When in standby mode, an H is displayed on any hot areas. None of the other hotplate displays will light up.
After use, disconnect the device using the control; do not rely on the cookware detector.
Locking the hob sensors
SAFETY FUNCTION
(models ...635, ...645, ...735 AB and ...622)
The safety function can be enabled after the hob is connected. To do so, touch sen-
sor 
(1) to enable the touch control. Immediately, touch the sensor 
(4) and hold it down for five seconds. An L (for 'Locked') will appear on the displays. The
GB
touch control will be switched off after a few seconds. If the cooking area is hot, an L and an H will appear alternately on the corresponding display.
This operation needs to be done within 10 seconds, with no sensor other than those indicated being touched during that time, or the locking will not be carried out.
The electronic control will remain locked until the user unlocks it, even after the con- trol is disconnected using the sensor 
(1)or when restarting after there has been a power cut.
Unlocking in order to cook
To unlock the control and use it, touch sen-
sor 
(1) to enable the touch control. Immediately touch the two 
sensors on the right at the same time. The L vanishes from the displays and a 0 appears with the lower point flashing, or an H if the corres- ponding hotplate is hot, and the hob will be ready to use for cooking. When you switch off the control using the on/off sensor 
(1)the safety function will be
Cancelling the safety function
The safety function can be permanently
disabled by pressing sensor 
for 5 seconds immediately after enabling the touch control. This should be done within 10 seconds after enabling the touch con- trol using the on/off sensor 
(1), and the safety function will be cancelled. If this is not done properly, the touch control will remain locked and will switch off after 20 seconds.
After cancelling the safety function, when the control is 
(1), the hob will be ready to be
17
