25
Operations
1
A message appears on the screen, confirming that you wish to shut off the power. To
shut off the power, press the ON/STANDBY button again. If you do not wish to shut off
the power, wait for a while without conducting any operations. The message will disap-
pear shortly. (This operation is no longer valid after the message disappears.)
2
The screen turns off, but the internal cooling fan continues to operate for a short while.
Then, the projector goes into standby mode.
A B
FLASH
A
Dur ing cooling ,the ON/STANDBY indicator flashes. In this state, the power can-
not be turned back on.
However, there is no problem with unplugging the power cord in this state.
B
In standby mode
Note
•Theprojectorconsumesabout6Wofpowerinstandby.Werecommendthatyouunplug
the power cord if you will not be using the projector for an extended period.
Precaution
•If the power cord is unplugged before cooling is complete, give the lamp time (about 5
minutes) to cool before plugging it back in. If the lamp overheats, it may fail to light.
•Rightafterturningoffthepower,theunitmaybecomeveryhot,especiallyairexhaust
and the bottom of the unit. Please handle with care to avoid burn injuries.
When cooling lamp After cooling complete