9
Before Using
POWER SUPPLY INFORMATION
If your line voltage is 220 to 240V, use one of the following types of cable/plug.
Plug
configuration Plug type
Australian
240V
10A
North American
240V
15A
Switzerland
240V
6A
Line voltage
EURO
UK
220 240V
220 240V
200 240V
200 240V
200 240V
Plug
configuration Plug type Line voltage
Use a 5A fuse which is approved by ASTA
or BSI to BSI362.
Always replace the fuse cover after
changing the fuse.
IMPORTANT PRECAUTIONS

Moisture Condensation

Never operate this unit immediately after moving it from a cold location to a warm location.
When the unit is exposed to such a change in temperature, moisture may condense on
the lens and the crucial internal parts. Do not use the unit for at least 2 hours when there
is an extreme or sudden change in temperature to prevent the unit from possible damage.

Place and Manner of Installation

•Donot placein hot locations,such asnear heating equipment.Doing socould cause
malfunction, and shorten the life of the projector.
•Avoidlocationswithoilorcigarettesmoke.Doingsowilldirtytheopticalparts,shortening
their lives, and darkening the screen.
•Donotuse thisproductinthe uprightpositionor tiltitup ordownbymorethan 20°from
level. Doing so may cause a failure or shorten the life of the product.
•Usingthis instrumentnear aTVor radiomaycause interferenceto theimages oraudio
sound. If this happens, move it away from the TV or radio.
•Movingtheprojectorfromalow-temperatureroomtoahigh-temperatureroommaycause
condensation on the lens or internal parts. If you continue to use it in that situation it may
malfunction. Wait until the condensation naturally disappears.
•Ina highaltitude locationwhere airisthin, coolingefciency isreduced souse thepro-
jector with [Fanmode] set to [High].
p.34