37
Maintenance
Lampreplacement
1

Unplug power cord.

2

Waituntillampissufcientlycooled.

Wait for at least 1 hour.
3

Removethelampcover.

Loosen the two screws, raise the lamp cover
with your fingers as shown to remove the lamp
cover. Use care to avoid any damage to nails
and/or tip of your finger(s). If you have any dif-
ficulty in removal, you can use a screwdriver or
any other smaller tool for your convenience.
4

Pulloutthelamp.

Loosen the two screws holding the lamp in place,
and pull up the handle to remove the lamp.
Lamp cover
1
2
3
A lamp is consumable supply. If used for extended periods, images will appear dark, and the
lamp could burn out. This is characteristic of a lamp, and is not malfunction. (The lifetime of
the lamp depends on condition of use.) If this happens, replace it with a new one
.

WARNING

•
Iftheprojectorismountedontheceiling,itisrecommendedtouseyourToshibadealer-
shipwhenthelamphastobeexchanged.
Uncovering the lamp while the projector is mounted on a ceiling may lead to a danger
of damage from falling pieces of glass if the lamp is broken. Besides, working at high
elevations can also be hazardous. Do not attempt to replace the lamp by yourself.
•Whenreplacing,alwaysuselamp“TLPLV10”(soldseparately). If the lamp other
than the specified one is used, it may cause a malfunction or damage to the unit due
to the difference in the connector shape or the lamp rate.

CAUTION

•
Ifyouhavebeenusingtheprojector,thelampwillbeveryhot,andmaycauseburn
injuries
.
Wait for the lamp to cool (for longer than 1 hour) before replacing it.
•
Ifthelampshouldbreak,pleasehandlewithcaretoavoidinjuryduetobroken
pieces and contact your dealer for repair service.
1
2
4