Scag Power Equipment SWZU manual Cutter Deck Belt Adjustments, Cutter Deck Adjustments

Page 13

10.To "freewheel" or move the machine around without the engine running, turn the dump valve levers located at the back of the pumps to the "freewheel" positions (see Figure 1). To operate the machine, the dump valve levers must be returned to the closed positions.

Dump Valve Levers

(normal position)

SGB112

Figure 1. Dump Valves

PITCH is the angle of the blades (comparing front to rear). A 1/4" downward pitch (front of deck down) is recommended for best cutting performance.

HEIGHT is the nominal distance the blade is off of the ground. This measurement is made with the blades pointed side to side and distance is measured between cutting tip and ground.

Changes to the cutting height can be achieved by reposi- tioning the cutter deck. There are eight available posi- tions from 1" to 4-1/2" (See Figure 2).

WARNING:

Do not adjust the cutting height with the mower blades rotating. Shut off the engine and remove the ignition key. Bodily injury could occur from the rotating blades.

1. Shut off the engine and remove the ignition key.

CUTTER DECK BELT ADJUSTMENTS

-NOTE-

All the belts on the SWZU are spring loaded and do not require adjustment. Check the belts for excessive wear or damage daily for the first week. After the first week, check the belts monthly.

1.Remove the belt covers.

2.Inspect the belts for wear, cracking, or glazing. Contact your Scag dealer if any unusual wear is noted.

3.Replace the belt covers.

2.While holding up on the deck support handle, remove the two hairpins from the adjusting pins on one side of the cutter deck (See Figure 2).

3.Lift or lower the deck to the desired cutting height and reinstall the hairpins. A deck height decal is located on the deck mounting frame as an aid in adjusting the deck to the desired height.

4.Repeat the above process on the opposite side of the cutter deck.

CUTTER DECK ADJUSTMENTS

Due to the many cutting conditions that exist, it is difficult to suggest a cutter deck setting that will work for every lawn. There are two adjustments that can be made on these decks, pitch and height.

Remove Hair Pins

SWU99DHA

Figure 2. Cutting Height Adjustment

9

Image 13

Contents 2003 Model SwzuRemember Your Mower is only AS Safe AS the Operator Table of Contents 44-45 Illustrated Parts ListIntroduction General InformationDirection Reference Servicing the Engine and Drive Train ComponentsISO Symbols CE Mark Fast Slow General Safety Information Safety InformationBefore Operation Considerations Before Operation Considerations Contd Rotating BladesOperation Considerations Maintenance and Storage Use gasoline with an octane rating no less than Mower OperationCutter Deck Adjustments Cutter Deck Belt AdjustmentsCustom-Cut Baffle Adjustment Cutter Deck Pitch AdjustmentsCutter Blades To Adjust the Custom-Cut Baffle height Neutral AdjustmentTracking Adjustment Steering Control ROD AdjustmentApply the parking brake Parking Brake Tracking AdjustmentLubrication & Maintenance Checking Hydraulic Oil Level Hydraulic SystemChanging Hydraulic Oil Changing Hydraulic Oil Filter ElementChecking Electrolyte Level and Cleaning Battery Engine Air CleanerChecking Engine Crankcase Oil Level Changing Engine Crankcase OilJump Starting Charging the BatteryCause Cure Troubleshooting Cutting ConditionsCondition Cause Cure Hitting Dirt or Cutting Very Close to Scalping BladesGround Step CutEngines Technical SpecificationsEngine Deck Drive SystemApproximate Dimensions SWZU36A SWZU48A SWZU52A SWZU61A Additional Specifications Optional ITEMS/ATTACHMENTSCutter Decks Page 36A Cutter Decks Ref. Part No. Number Description 48A, 52A & 61A Cutter Decks Part Description 36A Deck Frame 36A Deck Frame 48A and 52A Deck Frame Small Frame Ref. Part Description 48A and 52A Deck Frame *SMALL Frame52A & 61A Deck Frame Large Frame Part Description 52A 61A 52A & 61A Deck Frame *LARGE FrameEngine Deck Part Description Engine DeckDrive and Brake Components 15KA 17KA 21KAE 18KH 18HN Handle Assembly Small Frame Handle Assembly *SMALL Frame Handle Assembly Large Frame SWZU-21KAE Part Description Hydraulic Assembly Part Number Description Hydraulic AssemblyHydraulic Pump Assembly BDP-10L117 Hydraulic Pump Assembly Handle Wire Harness Manual Start Wire HarnessKohler 18 HP Ground Kawasaki 15 HP & 17 HPHandle Wiring Harness Kawasaki Electric Start Part no Wire Harness Adapter Heavy-Duty Replacement Decals & InformationSwzu 15KA, 17KA & 18HN Swzu 18KH Swzu 21 KAE Limited Warranty Commercial Equipment Comercial Equipo Limitada Garantía Continuación Técnicas Especificaciones SWZU61A SWZU52A SWZU48A APROXIMADASSWZU36A DimensionesOpcionales ARTÍCULOS/ACCESORIOS Adicionales EspecificacionesTransmisión DE Sistema Técnicas EspecificacionesSolución Causa Condición Corte DE Condiciones LAS EN Fallas DE IdentificaciónLa de ancho lo Corte de trayectoriaInclinadas Salientes Irregular perfil oPasadas entre cortar sin césped Corte de trayectoriasDe Franjas Vetas La en cortar sin céspedBatería la de Carga Puente por ArranqueCarga la durante producidos gases Electrolito de nivel del Verificación Batería de limpiezaBaterías manipular de después manos Las y chispas las arcos, los Mantenga .bateríasHidráulico Aceite de filtro del elemento del CambioHidráulico aceite de Cambio Hidráulico aceite de nivel el VerificarMantenimiento Y Lubricación Alineación de Ajuste .11 Figura PrecauciónNeutral Ajuste .9 Figura CON DE Varilla LA DE AjusteVelocidad de ajuste de palanca la Mueva Corte de deflector del 4 Posición .8 Figura Neutral AjusteCuchillas las de Afiliado .4 Figure Corte DE CuchillasPlataforma la de inclinación la de Ajuste .3 Figura DE Plataforma LA DE Ajustes CorteLA DE Correa LA DE Ajustes Corte de altura de Ajuste .2 FiguraChirrido un escuchar normal es desconectado Cortacésped DEL OperaciónAlmacenamiento Y Mantenimiento Operación DE Consideraciones Giratorias CuchillasMáquina la Si .baja corte de plataforma la con Advertencia Señalización de Palabra Seguridad DE InformaciónDescripción Símbolo ISO Símbolos Instrucciones DE Referencia General InformaciónIlustrada partes de Lista Contenido DE TablaTema Página Tema 52A-SWMU 61A-SWMU21KAE-SWZU Operador EL Como Seguro TAN ES Cortacésped ¡SU RecuerdeNo Parte 2003 Manual DEL Operador