Scag Power Equipment SWZU Checking Engine Crankcase Oil Level, Changing Engine Crankcase Oil

Page 20

2.Run the engine at idle speed with the speed control lever in neutral for five minutes.

3.Check the oil level in the hydraulic tank. It must be 2" inches from the top of the filler neck. If necessary, add SAE 20W50 motor oil.

Checking Engine Crankcase Oil Level

The engine oil level should be checked after every 8 hours of operation or daily as instructed in the Engine Operator’s Manual furnished with this mower.

Changing Engine Crankcase Oil

After the first 5 hours of operation, change the engine crankcase oil and replace the oil filter. Thereafter, change the engine crankcase oil after every 100 hours of operation or bi-weekly, whichever occurs first. Refer to the Engine Operator’s Manual furnished with this mower for instructions.

Changing Engine Oil Filter

After the first 5 hours of operation, replace the engine oil filter. Thereafter, replace the oil filter after every 200 hours of operation or every month, whichever occurs first. Refer to Engine Operator’s Manual for instructions.

Engine Air Cleaner

For any air cleaner, the operating environment dictates how often the air cleaner should be serviced. Refer to the Engine Operator’s Manual furnished with this mower for instructions.

-NOTE-

In extremely dusty conditions it may be necessary to service the air cleaner daily to prevent engine damage.

BATTERY (ELECTRIC START UNITS ONLY)

Checking Electrolyte Level and Cleaning Battery

This machine was equipped from the factory with a sealed battery. Maintenance is not required to maintain the electrolyte level. Dirt and fluid on the top of the battery can cause the battery to discharge. Corrosion of the battery terminals or loose connections will cause poor battery performance.

WARNING:

Lead-acid batteries produce flammable and explosive gases.To avoid personal injury when checking, testing or charging batteries, DO NOT use smoking materials near batteries. Keep arcs, sparks and flames away from batteries. Provide proper ventilation and wear safety glasses.

WARNING:

Battery posts, terminals, and related accessories contain lead and lead compounds, chemicals known to cause cancer and reproductive harm. Wash hands after handling.

1.Loosen the two plastic wing nuts and then remove the battery cover.

2.Clean the cable ends and battery posts with steel wool. Use a solution of baking soda and water to clean the battery. Do not allow the solution to enter the battery cells.

3.Tighten the cable connections securely and apply a light coat of silicone dielectric grease to the terminal connections to prevent corrosion.

4.Install the battery cover.

16

Page 19 Page 21
Image 20
Page 19 Page 21
Contents Model Swzu 2003Remember Your Mower is only AS Safe AS the Operator Table of Contents Illustrated Parts List 44-45General Information IntroductionDirection Reference Servicing the Engine and Drive Train ComponentsISO Symbols CE Mark Fast Slow Before Operation Considerations Safety InformationGeneral Safety Information Rotating Blades Before Operation Considerations ContdOperation Considerations Maintenance and Storage Mower Operation Use gasoline with an octane rating no less thanCutter Deck Belt Adjustments Cutter Deck AdjustmentsCutter Blades Cutter Deck Pitch AdjustmentsCustom-Cut Baffle Adjustment Neutral Adjustment To Adjust the Custom-Cut Baffle heightApply the parking brake Steering Control ROD AdjustmentTracking Adjustment Tracking Adjustment Parking BrakeLubrication & Maintenance Hydraulic System Checking Hydraulic Oil LevelChanging Hydraulic Oil Changing Hydraulic Oil Filter ElementEngine Air Cleaner Checking Electrolyte Level and Cleaning BatteryChecking Engine Crankcase Oil Level Changing Engine Crankcase OilCharging the Battery Jump StartingTroubleshooting Cutting Conditions Cause CureCondition Cause Cure Scalping Blades Hitting Dirt or Cutting Very Close toGround Step CutTechnical Specifications EnginesEngine Deck Drive SystemCutter Decks Additional Specifications Optional ITEMS/ATTACHMENTSApproximate Dimensions SWZU36A SWZU48A SWZU52A SWZU61A Page 36A Cutter Decks Ref. Part No. Number Description 48A, 52A & 61A Cutter Decks Part Description 36A Deck Frame 36A Deck Frame 48A and 52A Deck Frame Small Frame 48A and 52A Deck Frame *SMALL Frame Ref. Part Description52A & 61A Deck Frame Large Frame 52A & 61A Deck Frame *LARGE Frame Part Description 52A 61AEngine Deck Engine Deck Part DescriptionDrive and Brake Components 15KA 17KA 21KAE 18KH 18HN Handle Assembly Small Frame Handle Assembly *SMALL Frame Handle Assembly Large Frame SWZU-21KAE Part Description Hydraulic Assembly Hydraulic Assembly Part Number DescriptionHydraulic Pump Assembly BDP-10L117 Hydraulic Pump Assembly Wire Harness Handle Wire Harness Manual StartKohler 18 HP Ground Kawasaki 15 HP & 17 HPHandle Wiring Harness Kawasaki Electric Start Part no Wire Harness Adapter Replacement Decals & Information Heavy-DutySwzu 15KA, 17KA & 18HN Swzu 18KH Swzu 21 KAE Limited Warranty Commercial Equipment Comercial Equipo Limitada Garantía SWZU61A SWZU52A SWZU48A APROXIMADASSWZU36A Dimensiones Continuación Técnicas EspecificacionesOpcionales ARTÍCULOS/ACCESORIOS Adicionales EspecificacionesTécnicas Especificaciones Transmisión DE SistemaCorte DE Condiciones LAS EN Fallas DE Identificación Solución Causa CondiciónCorte de trayectoria La de ancho loInclinadas Salientes Irregular perfil oCorte de trayectorias Pasadas entre cortar sin céspedDe Franjas Vetas La en cortar sin céspedCarga la durante producidos gases Puente por ArranqueBatería la de Carga Batería de limpieza Electrolito de nivel del VerificaciónBaterías manipular de después manos Las y chispas las arcos, los Mantenga .bateríasAceite de filtro del elemento del Cambio HidráulicoHidráulico aceite de Cambio Hidráulico aceite de nivel el VerificarMantenimiento Y Lubricación Precaución Alineación de Ajuste .11 FiguraVelocidad de ajuste de palanca la Mueva CON DE Varilla LA DE AjusteNeutral Ajuste .9 Figura Neutral Ajuste Corte de deflector del 4 Posición .8 FiguraPlataforma la de inclinación la de Ajuste .3 Figura Corte DE CuchillasCuchillas las de Afiliado .4 Figure Corte DE Plataforma LA DE AjustesLA DE Correa LA DE Ajustes Corte de altura de Ajuste .2 FiguraCortacésped DEL Operación Chirrido un escuchar normal es desconectadoAlmacenamiento Y Mantenimiento Máquina la Si .baja corte de plataforma la con Giratorias CuchillasOperación DE Consideraciones Advertencia Seguridad DE Información Señalización de PalabraDescripción Símbolo ISO Símbolos General Información Instrucciones DE ReferenciaTema Contenido DE TablaIlustrada partes de Lista Página Tema 61A-SWMU 52A-SWMU21KAE-SWZU Operador EL Como Seguro TAN ES Cortacésped ¡SU RecuerdeManual DEL Operador No Parte 2003
Top Page Image Contents