Maintenance and Storage

1.Allow only trained personnel to service the machine.

2.Never make adjustments to the machine with the engine running unless specifically instructed to do so. If the engine is running, keep hands, feet, and clothing away from moving parts.

3.Remove the key from the ignition switch and disconnect the wire from the spark plug(s) to prevent accidental starting of the engine when servicing, adjusting or storing the machine.

4.If the mower must be tipped to perform maintenance or adjustment, remove the battery, drain the gasoline from the fuel tank and the oil from the crankcase.

5.Be sure the machine is in safe operating condition by keeping nuts, bolts, and screws tight. Check the blade mounting bolts and nuts frequently to be sure they are tightened.

6.Do not change the engine governor settings or overspeed the engine. See the engine operator's manual for information on engine settings.

7.To reduce fire hazard, keep the engine free of grass, leaves, excessive grease, oil and dirt.

8.The engine must be shut off before checking the oil or adding oil to the crankcase.

9.Allow the engine to cool before storing the mower in any enclosure such as a garage or storage shed. Make sure the fuel tank is empty if the machine is to be stored in excess of 30 days. Do not store the mower near any open flame or where gasoline fumes may be ignited by a spark.

10.Always store gasoline in a safety-approved, red container.

11.Be careful when servicing the battery as it contains acid, which is corrosive and could cause burns to skin and clothing.

12.Batteries release explosive gases when being charged or discharged. Keep batteries away from any source of sparks and/or flame.

13.Make sure all hydraulic fluid connections are tight and all hydraulic hoses and lines are in good condition before starting the machine.

14.Hydraulic fluid is under high pressure. Keep body and hands away from pinholes or nozzles that eject hydraulic fluid under high pressure. If you need service on your hydraulic system, please see your authorized Scag dealer. Hydraulic fluid under high pressure may have sufficient force to penetrate skin and cause serious injury. If hydraulic fluid is injected into the skin, it must be surgically removed within a few hours by a doctor or gangrene may result.

INITIAL RUN-IN PROCEDURES (FIRST DAY OF USE OR APPROXIMATELY 10 HOURS)

1.Check the steering control rods and the speed control for neutral adjustment. (See Adjust ments, page 11-12)

2.Check the tires for proper pressure.

Caster Wheels	25 psi.
Drive Wheels	12 psi.

3.Check for loose hardware. Tighten as needed.

4.Check the safety switches for proper adjustment:

*On electric start machines the engine should crank and start if the machine is in neutral, the PTO engagement switch is OFF and the parking brake is ON.

5.Apply lubricant to all the grease fittings. Lubricant was applied at the factory. This is just a precautionary check to make sure that all the fittings have been lubricated.