RedMax GZ4000 manual Symbols on the machine, Position Fuel cap, Position Oil cap, Emission Control

English

4. Symbols on the machine

	For safe operation and maintenance,
	symbols are carved in relief on the
	machine.
	According to these indications, please
	be careful not to make any mistake.
(a)	(a) The port to refuel “MIX GASOLINE”
	Position: Fuel cap
	(b) The port to top up chain oil
(b)
	Position: Oil cap
(c)	(c) Setting the switch to the “O” position, the engine
	stops immediately.
	Position: Rear-left of the unit
	(d) Starting the engine. If you pull out the choke knob
(d)
	(at the back-right of the rear handle) to the point of
	the arrow, you can set the starting mode as follows:
	• First-stage position – starting mode when the
	engine is warm.
	• Second-stage position – starting mode when the
	engine is cold.
	Position: Upper-right of the aircleaner cover

(e)	(e) The screw under the “H” stamp is The High-speed
	adjustment screw.
	The screw under the “L” stamp is The Slow-speed
	adjustment screw.
	The screw at the left of the “T” stamp is the Idle
	adjustment screw.
	Position: Left side of the rear handle
	(f) Shows the directions that the chain brake is
(f)
	released (white arrow) and activated (black arrow).
	Position: Front of the chain cover
(g)	(g) If you turn the rod by screwdriver follow the arrow
	to the "MAX" position, the chain oil flow more, and if
	you turn to the "MIN" position, less.
	Position: Bottom of the power unit
	■ EMISSION CONTROL
	An emission control label is located on the engine.
	IMPORTANT ENGINE INFORMATION
	THIS ENGINE MEETS U.S. EPA PH2 AND 2006
	CALIFORNIA EMISSION REGULATIONS FOR SI
	SORE’s COMPLIANCE PERIOD : CATEGORY B
	ENGINE FAMILY : 6KZXS. 0404FG ; EM
	ENGINE DISPLACEMENT : 40cc
	REFER TO OWNER’S MANUAL FOR MAINTE-
	NANCE SPECIFICATIONS AND ADJUSTMENTS.
	MANUFACTURED :
	MADE IN JAPAN
	Use RedMax 50:1 Oil !

8