RedMax LRTZ2500 manual  14 , Recommended Mixing Ratio Gasoline 50OIL, HOW to MIX Fuel

Page 14

7. Fuel

50:1 MIXING CHART

GASOLINE

gal.

1

2

3

4

5

 

 

 

 

 

 

2-CYCLE OIL fl.oz

2.6

5.2

7.8

10.4

13

 

 

 

 

 

 

 

 

 

 

 

 

 

 

GASOLINE

liter

1

2

3

4

5

 

 

 

 

 

 

 

2-CYCLE OIL

ml

20

40

60

80

100

 

 

 

 

 

 

 

14

WARNING

Gasoline is very flammable. Avoid smoking or bringing any flame or sparks near fuel. Make sure to stop the engine and allow it cool before refueling the unit. Select outdoor bare ground for fueling and move at least 3m(10ft) away from the fueling point before starting the engine.

The RedMax engines are lubricated by oil specially formulated for air-cooled 2-cycle gasoline engine use. If RedMax oil is not available, use an anti-oxidant added quality oil expressly labeled for air-cooled 2-cycle engine use. (JASO FC GRADE OIL or ISO EGC GRADE)

RECOMMENDED MIXING RATIO

GASOLINE 50:OIL 1

Exhaust emission are controlled by the fundamental engine parameters and components(eq., carburation, ignition timing and port timing) without addition of any major hardware or the introduction of an inert material during combustion.

These engines are certified to operate on unleaded gasoline.

Make sure to use gasoline with a minimum octane number of 90 ROZ(USA/Canada : pump octane min.87)

Unleaded gasoline is recommended to reduce the contamination of the air for the sake of your health and the environment.

Poor quality gasolines or oils may damage sealing rings, fuel lines or fuel tank of the engine.

HOW TO MIX FUEL

1.Measure out the quantities of gasoline and oil to be mixed.

2.Put some of the gasoline into a clean, approved fuel container.

3.Pour in all of the oil and agitate well.

4.Pour in the rest of gasoline and agitate again for at least one minute.

5.Put a clear indication on the outside of the

Image 14
Contents LRTZ2500 Information Safety First Contents 4  SpecificationsParts location Symbols on the machine  5 Working Circumstance For safe operationWorking Condition  6 Working Plan  7  8  Before Starting the EngineStarting the Engine Using the Product  9  10  MaintenanceIf Someone Comes  11  Handling FuelTransportation Set up  12  13  SE4 Attaching the Trimming Mechanism SE4Balance Unit  14  HOW to MIX FuelFuel Recommended Mixing Ratio Gasoline 50OIL 15  Fueling the UnitFor Your Engine LIFE, Avoid OP3 OP4 Starting Engine OperationOP1  16 OP5 Adjusting Throttle CableAdjusting Idling Speed OP6 OP6 Stopping Engine OP3 18  Adjusting the Angle of the Cutting Blades OP7OP7 Blades MA1 MaintenanceMaintenance Chart 19 AIR Filter MA2 MA3 MA4 Quick TIPGear Case Fuel Filter 21   22  Procedures to be Performed After Every 100 Hours of USEMA8 Intake AIR Cooling VentStorage  23  24  Troubleshooting guideCheck Probable Causes Action Parts list  25 Drive Unit LRTZ2500 S/N 000000 and up  26  27  Engine Unit LRTZ2500 S/N 000479 and up  28  29  Manufacturer’s warranty coverage Model LRTZ2500 Year Limited Warranty RemedyKomatsu Zenoah America INC