RedMax LRTZ2500 manual Manufacturer’s warranty coverage

Page 30

CALIFORNIA EMISSION CONTROL WARRANTY STATEMENT

YOUR WARRANTY RIGHTS AND OBLIGATIONS

The California Air Resources Board and KOMATSU ZENOAH are pleased to explain the emission control system warranty on your 1995 and later small off-road engine. In California, new small off-road engines must be designed, built and equipped to meet the state’s stringent anti-smog standards. KOMATSU ZENOAH must warrant the emission control system on your small off-road engine for the periods of time listed below provided there has been no abuse, neglect or improper maintenance of your small off-road engine.

Your emission control system may include parts such as the carburetor and the ignition system.

Where a warrantable condition exists, KOMATSU ZENOAH will repair your small off-road engine at no cost to you including diagnosis, parts and labor.

Manufacturer’s warranty coverage:

The 1995 and later small off-road engines are warranted for two years. If any emission- related part on your engine is defective, the part will be repaired or replaced by

KOMATSU ZENOAH.

Owner’s warranty responsibilities:

As the small off-road engine owner, you are responsible for the performance of the required maintenance listed in your owner’s manual. KOMATSU ZENOAH recommends that you retain all receipts covering maintenance on your small off-road engine, but KOMATSU ZENOAH can not deny warranty solely for the lack of receipts or for your failure to ensure the performance of all scheduled maintenance.

As the small off-road engine owner, you should be aware, however, that KOMATSU ZENOAH may deny you warranty coverage if your small off-road engine or a part has failed due to abuse, neglect, improper maintenance or unapproved modification.

You are responsible for presenting your small off-road engine to a KOMATSU ZENOAH distribution center as soon as a problem exists. The warranty repairs should be completed in e reasonable amount of time, not to exceed 30 days.

If you have any questions regarding your warranty rights and responsibilities, you should contact KOMATSU ZENOAH AMERICA INC. at (770)-381-5147 or you can write to

KOMATSU ZENOAH AMERICA INC.

4344 Shackleford Road Suite 500

Norcross, Georgia 30093

Image 30
Contents LRTZ2500 Information Safety First ContentsSpecifications Parts location 4  Symbols on the machine  5 Working Circumstance For safe operationWorking Condition  6 Working Plan  7 Before Starting the Engine Starting the Engine 8  Using the Product  9 Maintenance If Someone Comes 10  Handling Fuel Transportation 11  Set up  12 SE4 Attaching the Trimming Mechanism SE4 Balance Unit 13   14  HOW to MIX FuelFuel Recommended Mixing Ratio Gasoline 50OILFueling the Unit For Your Engine LIFE, Avoid 15  OP3 OP4 Starting Engine OperationOP1  16 OP5 Adjusting Throttle CableAdjusting Idling Speed OP6 OP6 Stopping Engine OP3Adjusting the Angle of the Cutting Blades OP7 OP7 18  Blades MA1 MaintenanceMaintenance Chart 19 AIR Filter MA2 MA3 MA4 Quick TIPGear Case Fuel Filter 21   22  Procedures to be Performed After Every 100 Hours of USEMA8 Intake AIR Cooling VentStorage  23 Troubleshooting guide Check Probable Causes Action 24  Parts list  25 Drive Unit LRTZ2500 S/N 000000 and up  26  27  Engine Unit LRTZ2500 S/N 000479 and up  28  29  Manufacturer’s warranty coverage Model LRTZ2500 Year Limited Warranty RemedyKomatsu Zenoah America INC