RedMax LRTZ2500 manual Before Starting the Engine,  8 

Page 8

5. For safe operation

BEFORE STARTING THE ENGINE

1.The area within a perimeter of 50 feet (15m) of the person using the product should be considered a hazardous area into which no one should enter. If necessary yellow warning rope, warning signs should be placed around the perimeter of the area. When work is to be performed simultaneously by two or more persons, care should also be taken to constantly look around or otherwise check for the presence and locations of other people working so as to maintain a distance between each person sufficient to ensure safety.

2.Check the condition of working area to avoid any accident by hitting hidden obstacles such as stumps, stones, cans, or broken grass.

IMPORTANT

Remove any obstacle before beginning work.

3.Inspect the entire unit for loose fasteners and fuel leakage. Make sure that the cutting attachment is properly installed and securely fastened.

4.Always use the shoulder strap. Adjust the strap for comfort before starting the engine. The strap should be adjusted to fit your body according as your working posture.

STARTING THE ENGINE

1.Keep bystanders and animals at least 50feet (15m) away from the operating point. If you are approached, immediately stop the engine.

2.The product is equipped with a centrifugal clutch mechanism, so the cutting attachment begins to rotate as soon as the engine is started by putting the throttle into the start position. When starting the engine, place the product onto the ground in a flat clear area and hold it firmly in place so as to ensure that neither the cutting part nor the throttle come into contact with any obstacle when the engine starts.

8

Image 8
Contents LRTZ2500 Information Safety First Contents 4  SpecificationsParts location Symbols on the machine  5 For safe operation Working ConditionWorking Circumstance  6 Working Plan  7  8  Before Starting the EngineStarting the Engine Using the Product  9  10  MaintenanceIf Someone Comes  11  Handling FuelTransportation Set up  12  13  SE4 Attaching the Trimming Mechanism SE4Balance Unit HOW to MIX Fuel Fuel 14  Recommended Mixing Ratio Gasoline 50OIL 15  Fueling the UnitFor Your Engine LIFE, Avoid Operation OP1OP3 OP4 Starting Engine  16 Adjusting Throttle Cable Adjusting Idling Speed OP6OP5 OP6 Stopping Engine OP3 18  Adjusting the Angle of the Cutting Blades OP7OP7 Maintenance Maintenance ChartBlades MA1 19 MA2 MA3 MA4 Quick TIP Gear CaseAIR Filter Fuel Filter 21  Procedures to be Performed After Every 100 Hours of USE MA8 22  Intake AIR Cooling VentStorage  23  24  Troubleshooting guideCheck Probable Causes Action Parts list  25 Drive Unit LRTZ2500 S/N 000000 and up  26  27  Engine Unit LRTZ2500 S/N 000479 and up  28  29  Manufacturer’s warranty coverage Model LRTZ2500 Year Limited Warranty RemedyKomatsu Zenoah America INC