RedMax LRTZ2500 manual Adjusting the Angle of the Cutting Blades OP7,  18 

Page 18

8. Operation

OP7

is in operation.

Always be sure to turn off the engine before changing the angle of the blades, removing branches which have become stuck in the blades, or at any other time when coming into close proximity with the blades.

Always wear work gloves made of leather or some other sturdy material when using the trimmer.

Always place the blade cover provided with the trimmer over the blades when not in use.

Falling branches may fall onto the face or into the eyes, resulting in injuries, scratches, and cuts, and for this reason you should always be sure to wear a helmet and face protector when using your trimmer.

IMPORTANT

The thickness of branches which may be cut using this trimmer is limited to up to approximately 3/16" (5mm). Never try to cut branches thicker than this, as doing so may result in damage to the trimmer.

ADJUSTING THE ANGLE OF THE CUTTING BLADES (OP7)

1.Stop the engine.

2.Turn the bolt located on the top of the trimming mechanism counter-clockwise to loosen it.

3.Adjust the angle of the blades to the desired angle, and then fix the bolt firmly back into place.

(1)Clamp lever

(2)Trimming mechanism

18

Image 18
Contents LRTZ2500 Information Safety First ContentsSpecifications Parts location 4  Symbols on the machine  5 Working Circumstance For safe operationWorking Condition  6 Working Plan  7 Before Starting the Engine Starting the Engine 8  Using the Product  9 Maintenance If Someone Comes 10  Handling Fuel Transportation 11  Set up  12 SE4 Attaching the Trimming Mechanism SE4 Balance Unit 13   14  HOW to MIX FuelFuel Recommended Mixing Ratio Gasoline 50OILFueling the Unit For Your Engine LIFE, Avoid 15  OP3 OP4 Starting Engine OperationOP1  16 OP5 Adjusting Throttle CableAdjusting Idling Speed OP6 OP6 Stopping Engine OP3Adjusting the Angle of the Cutting Blades OP7 OP7 18  Blades MA1 MaintenanceMaintenance Chart 19 AIR Filter MA2 MA3 MA4 Quick TIPGear Case Fuel Filter 21   22  Procedures to be Performed After Every 100 Hours of USEMA8 Intake AIR Cooling VentStorage  23 Troubleshooting guide Check Probable Causes Action 24  Parts list  25 Drive Unit LRTZ2500 S/N 000000 and up  26  27  Engine Unit LRTZ2500 S/N 000479 and up  28  29  Manufacturer’s warranty coverage Model LRTZ2500 Year Limited Warranty RemedyKomatsu Zenoah America INC