Poulan PP025 instruction manual Engine, Troubleshooting Table, Other, Trouble Cause Remedy

Page 14

HELPFUL TIP

During storage of your gas/ oil mixture, the oil will sepa- rate from the gas.

We recommend that you shake the gas can weekly to insure proper blending of the gas and oil.

ENGINE

SRemove spark plug and pour 1 teaspoon of 40:1, 2-cycle engine oil (air cooled) through the spark plug opening. Slowly pull the starter rope 8 to 10 times to distribute oil.

TROUBLESHOOTING TABLE

SReplace spark plug with new one of recom- mended type and heat range.

SClean air filter.

S Check entire unit for loose screws, nuts, and bolts. Replace any damaged, broken, or worn parts.

SAt the beginning of the next season, use only fresh fuel having the proper gasoline to oil ratio.

OTHER

SDo not store gasoline from one season to

another.

SReplace your gasoline can if it starts to rust.

WARNING: Always stop unit and disconnect spark plug before performing all of the recommended remedies below except remedies that require operation of the unit.

 

TROUBLE

CAUSE

REMEDY

 

 

 

 

 

 

Engine will not

1.ON/OFF switch in

1.

Move ON/OFF switch to the ON

 

start.

 

OFF position.

 

position.

 

 

2.

Engine flooded.

2.

See “Starting a Flooded Engine” in

 

 

3.

Fuel tank empty.

 

Operation Section.

 

 

3.

Fill tank with correct fuel mixture.

 

 

4.

Spark plug not firing.

4.

Install new spark plug.

 

 

5.

Fuel not reaching

5.

Check for dirty fuel filter; replace.

 

 

 

carburetor.

 

Check for kinked or split fuel line;

 

 

6.

Carburetor requires

 

repair or replace.

 

 

6.

Contact an authorized service dealer.

 

 

 

adjustment.

 

 

 

 

 

 

 

 

Engine will

1. Carburetor requires

1.

See “Carburetor Adjustment” in

 

not idle

 

adjustment.

 

Service and Adjustments Section.

 

properly.

2. Crankshaft seals worn.

2.

Contact an authorized service dealer.

 

 

3.

Compression low.

3.

Contact an authorized service dealer.

 

Engine will not

1.

Air filter dirty.

1.

Clean or replace air filter.

 

accelerate,

2. Spark plug fouled.

2.

Clean or replace plug

 

lacks power,

 

 

 

and regap.

 

or dies under

3. Carburetor requires

3.

Contact an authorized service dealer.

 

a load.

4.

adjustment.

4.

Contact an authorized service dealer.

 

 

Carbon build-up on

 

 

 

muffler outlet screen.

 

 

 

 

5.

Compression low.

5.

Contact an authorized service dealer.

 

Engine

1. Fuel mixture incorrect.

1. Empty fuel tank and refill with

 

smokes

 

 

 

correct fuel mixture.

 

excessively.

2.

Air filter dirty.

2. Clean or replace air filter.

 

 

3.

Carburetor requires

3. Contact an authorized service dealer.

 

 

 

adjustment.

 

 

 

Engine runs

1. Fuel mixture incorrect.

1. See “Fueling Engine” in Operation

 

hot.

2. Spark plug incorrect.

 

section.

 

 

2. Replace with correct spark plug.

 

 

3. Carburetor requires

3. Contact an authorized service dealer.

 

 

 

adjustment.

 

 

 

 

4. Carbon build-up on

4. Contact an authorized service dealer.

 

 

 

muffler outlet screen.

 

 

14

Image 14
Contents PP025 Unit / Maintenance Safety Safety RulesOperator Safety Edger Safety Fuel SafetyLine Trimmer Safety Transporting and StorageCultivator Safety BLOWER/VACUUM SafetyBrushcutter Safety For damage Hedge Trimmer SafetyPole Pruner Safety Cover in place and properly securedInstalling Trimmer ATTACH- Ment AssemblySnow Thrower Safety Primary Hole Adjusting the Assist HandleAttaching Shield Secondary HoleOperation Starting a Cold Engine HOW to Stop Your UnitHOW to Start Your Unit Starting a Warm EngineTrimmer Line Advance Installing Optional ATTACH- MentsOperating Position Inches 8 cm above ground MaintenanceCutting Methods Service and Adjustments Fuel System Carburetor AdjustmentSeasonal Storage PortingOther Troubleshooting TableEngine Trouble Cause RemedyLimited Warranty Ligations The U.S. EnvironmentalService 800--554--6723