Craftsman 358.79558 instruction manual Starting a Warm Engine, Operating Position, Cutting Methods

Page 7

Choke position

STARTING A WARM ENGINE

1.Move the choke lever to the HALF CHOKE position.

2.Squeeze and held the throttle trig- ger. Keep throttle trigger fully squeezed until the engine runs smoothly.

3.Pull starter rope sharply until engine runs, but no more than 5 pulls.

4.Allow engine to run 15 seconds, then move the choke lever to the OFF CHOKE position.

NOTE: If engine has not started, pull starter rope 5 more pulls. If engine still does net run, it is probably flooded,

STARTING A FLOODED ENGINE Flooded engines can be started by placing the choke lever in the OFF CHOKE position; then, pull the rope to clear the engine of excess fuel. This could require pulling the starter handle many times depending on hew badly the unit is flooded,

If the unit still doesn't start, refer to TROUBLESHOOTING TABLE or call 1-800-235-5878.

OPERATING POSITION

Long Pat_

When operating unit, stand as shown and check for the following:

Wear eye protection and heavy clothing.

Hold trigger handle with right hand and assist handle with left hand.

Keep unit below waist level,

Cut only from your left to your right to ensure debris is thrown away from

you, Without bending over, keep line near and parallel to the ground and

not crowded into material being cut. Do not run the engine at a higher speed than necessary. The cutting line will cut efficiently when the engine is run at less than full throttle. At lower speeds, there is less engine noise and vibration. Always release the throttle trigger and allow the engine to return to idle speed when not cutting.

To stop engine:

Release the throttle trigger.

Push and release the engine ON/ STOP switch.

CUTTING METHODS

_Jh_WARNING: Use minimum

speed and de not crowd the line when cutting around hard objects (rock,

gravel, fence posts, etc.), which can damage the trimmer head, become entangled in the line, or be thrown causing a serious hazard.

The tip of the line does the cutting. You will achieve the best perform* ance and minimum line wear by net crowding the line into the cutting area. The right and wrong ways are shown below.

Tip of line does the Line crowded into

cutting

work area

Cut onI_

QWARNING: Always wear eye protection. Never lean over the trimmer head. Rocks or debris can ricochet or

be thrown into eyes and face and cause blindness or other serious injury.

RightWrong

The line will easily remove grass and weeds from around walls, fences, trees and flower beds, but it also can cut the tender bark of trees or shrubs and scar fences.

For trimming or scalping, use less than full throttle to increase line life and decrease head wear, especially:

During light duty cutting,

Near objects around which the line can wrap such as small posts, trees or fence wire.

7

Image 7
Contents Gasoline Weedwacker Sears, Roebuck and Co., D/817WA, Hoffman Estates, IL This power unit can be dangerous! OpCutting Safety Operator SafetyUnit / Maintenance Safety Fuel SafetyAttaching Shield Carton ContentsAssembly Adjusting the HandleBefore Starting Engine Know Your TrimmerStarting a Cold Engine or a warm engine after running out HOW to Start Your UnitStartinga Flooded Engine Operating Position Starting a Warm EngineCutting Methods ScalpingSweeping Maintenance Schedule Care & Maintenance TaskWhen To Perform TrimmingMowingReplace Spark Plug Line ReplacementCheck for Loose Fasteners and Parts Check for Damaged or Worn PartsIdle Speed Adjustment Carburetor AdjustmentReplacing the Cutting Head Fuel System Seasonal StorageEngine Your Warranty Rights TroubleshootingManufacturers Warranty Or Replacement of PARTS. Re Warranty Commencement Date The warranty period begins onNANCE, Replacement and RE- Pair of Emission Related DE Seguridad Sears, Roebuck and Co., D/817 WA, Hoffman Estates, ILJadvertencia Manual DE InformacionSeguridad DEL Aparato Y EN EL Mantenimiento Seguridad DEL UsuarioSeguridad CON EL Combustible Transporte Y Almacenamiento Seguridad AL CortarAjuste DEL Mango Iadvertencia Contenido DE LA CajaModelo MontajeCebador Interruptor ON/STOPAntes DE Poner EN Marcha EL Motor Comprende las reglas de seguridadPara Poner EN Marcha EL Motor ImportantePara Detener EL Motor Full ChokePosicion DE USO Ranque DE Motor AhogadoPapa Arrancar CON EL Motor Caliente Arranque DE Motor AhogadoMetodos DE Corte II!IADVERTENCIA Nohagamarcharelmotora revoluLimpie EL Filtro DEL Aire Cronograma DE MantenimientoRecomendaciones Generales Inspeccione Y Limpie EL Apara To Y SUS PlacasReemplazo DE LA Linea EN EL Cabezal DE Corte DE LiNEA Cambie LA BujiaFija Lk Advertencia Reemplazo DE LA Cabezal DE CorteAjuste AL Carburador Marcha LentaOtros Sintoma Tabla DiagnosticaSUS Derechos Y Obligaciones Garantizadas Reemplazo ReparacionPiezas Relacionadas CON LA Piezas DE Control