Snapper RP2167519B, RP217019BVE, RP216019KWV Stopping, Handle Height Adjustment, Propelling Mower

Section 2 - OPERATING INSTRUCTIONS

2.2STARTING & OPERATION

2.2.1.ENGINE & BLADE (Kawasaki Engine)

1.Make sure fuel valve on engine is open. See Figure 2.5.

FUEL

VALVE

CLOSE

OPEN

FIGURE 2.5

2.Move engine speed control past “Fast” detent to “Choke” position. See Figure 2.4 and

“FAMILIARIZATION”.

3.Pull blade control against handle.

4.Pull rope start handle to crank engine.

5.After engine starts, turn off choke, reduce engine speed, and allow a brief warm-up until engine runs smooth.

NOTE: Stop the engine (and blade) by releasing the blade control.

2.3STOPPING

Stop forward motion of mower by releasing the wheel drive control. Stop engine and blade by releasing the blade control.

2.4HANDLE HEIGHT ADJUSTMENT

The height of the mower handle can be adjusted as follows:

1. Loosen the lower nuts on each lower handle as shown in Figure 2.7.

HIGHER

LOWER

HANDLE

LOWER

LOOSEN LOWER

NUTS ON EACH

LOWER HANDLE

FIGURE 2.7

2.Move upper mower handle up or down until the desired position is achieved.

3.Tighten the lower nuts on each lower handle to maintain desired position.

2.2.3. PROPELLING MOWER

(Self Propelled Models Only)

1. Start engine. Refer to Section “Starting &

Operation”.

2. Move ground speed control to the desired speed

position. See Figure 2.6.

3. Move wheel drive control against handle to

engage wheel drive and propel mower forward.

Forward speed can be adjusted while the mower is

moving by changing position of the ground speed

WARNING

STOP engine and mower blade by releasing the blade control before adjusting cutting height or handle height.

2.5CUTTING HEIGHT ADJUSTMENT

1. Pull the height adjusting latch outward and move to desired cutting height. See Figure 2.8.

control. See Figure 2.6.

	ENGAGE
WHEEL	SLOWER
	GROUND
DRIVE
	SPEED
CONTROL
	CONTROL
	FASTER

FIGURE 2.6

LOWEST CUTTING

1 HEIGHT

1

2

3

4

5

6

7

LATCH

HIGHEST 7 CUTTING HEIGHT

FIGURE 2.8

8