Snapper How to Prepare the Engine, Check the Tires, Check the Level of the Mower Deck

Page 12

How to Prepare the Engine

NOTE: The engine was shipped from the factory filled with oil. Check the level of the oil. Add oil as needed.

NOTE: The operation of a new engine will sometimes result in a slight amount of smoke. This smoke is caused by paint or oil on or around the muffler. This is normal and only expected during initial operation.

A separate engine manual is also included with the unit. See this engine manual for the manufacturer’s instructions for the type of gasoline and oil to use. Before you use the unit, read the information on safety, operation, maintenance, and storage.

WARNING: Follow the engine manufacturer’s instructions for the type of gasoline and oil to use. Always use a safety gasoline container. Do not smoke when adding gasoline to the engine. When inside an enclosure, do not fill with gasoline. Before you add gasoline, stop the engine. Let the engine cool for several minutes.

IMPORTANT: This unit is equipped with an internal combustion engine and must not be used on or near any unimproved forest-covered, brush-covered or grass-covered land unless the engine’s exhaust system is equipped with a spark arrester meeting applicable local or state laws (if any). If a spark arrester is used, it must be maintained in effective working order by the operator.

In the State of California the above is required by law (Section 4442 of the California Public Resources Code). Other states may have similar laws. Federal laws apply on federal lands. See an Authorized Service Center for a spark arrester for the muffler.

In some areas, local law requires the use of a resistor spark plug to control the ignition signals. See an Authorized Service Center for a resistor spark plug for the engine.

NOTE: Actual sustained horsepower will likely be lower due to operating limitations and environmental factors.

Check the Tires

NOTE: The tires may be over inflated for shipment.

Check the air pressure in the tires. Tires with too much air pressure will cause the unit to ride rough. Also, the wrong air pressure will keep the mower housing from cutting level. Recommended air pressure is 14 PSI (1 BAR).

Check the Level of the Mower Deck

Make sure the level of cut is still correct. After you mow a short distance, look at the area that was cut. If the mower deck does not cut level, see the instructions on “How To Level The Mower Deck” in the Maintenance section of this instruction book.

English

10

www.snapper.com

Page 11 Page 13
Image 12
Page 11 Page 13
Contents Lawn Tractor Series Where to Find Us Mower EngineDate Purchased Table of Contents Protection for Children Protection against TipoversPreparation Do not allow pre-teenage children to operate machineSafe Handling of Gasoline Towing International Pictorials GhijAssembly Parts Bag ContentsInstalling the Seat Assembling the Steering WheelMaintenance Free Battery How to Install the Battery CablesRemove the protective cap from the battery terminal How To Check The Safety Interlock SwitchesIMPORTANT! Before You Start Mowing Operator Presence System SeatHow to Prepare the Engine Check the TiresCheck the Level of the Mower Deck Features and Controls Using Controls How to Use the Throttle ControlHow to Engage the Blades 42 Models OperationHow to Engage the Blades 46 & 52 models How to Use the Speed Control PedalDriving and Stopping the Unit How to Use the Cruise Control How to Drive in ReverseHow to Change Direction Push the brake pedalHow to Set the Parking Brake How to Change the Cutting HeightHow to Stop the Unit How to Transport the Unit How to Operate the Mower DeckRemove the key to restrict access to the RMO feature MowingHow to Operate the Unit on Hills How to Stop on a HillHow to Start Operation on a Hill How to Start the Engine Engine OperationBefore Starting the Engine Check the Oil Add GasolineTips Operating TipsMowing and Bagging Tips Use the left side of the mower deck to trim near an objectMaintenance Maintenance ScheduleFrequency Maintenance Required Comments Maintenance engine Examine bladesHow to Check the Muffler How to Remove and Install the BladeGeneral Recommendations InspectionAdjustments How to Sharpen the BladeHow to Adjust the Blade Rotation Control 42 Models Blade engage cable adjustment Blade engage cable bracket How to Check and Adjust the PTO Clutch 46 & 52 Models Blade Brake Check 46 & 52 Models OnlyHow to Check and Adjust the Motion Drive Belt Remove the 1/4 inch 6 mm pin or bolt FigureHow to Remove the Battery How to Clean the BatteryHow to Charge the Battery Before you charge the battery, remove the batteryWhere to Lubricate LubricationMower Deck Maintenance How to Check the Fuel FilterHow to Install the Mower Deck 42 Models Remove the mower drive belt from the stack pulleyMower driver belt V Belt guide Stack pulley How to Remove the Mower Deck 46 & 52 Models How to Install the Mower Deck 46 & 52 ModelsHanger rod Q Adjuster arm How to Adjust the Gauge Wheels How to Level the Mower DeckRemove the gauge wheels Figure Loosening adjuster knobs Lift link Adjuster knobs Replacing the Motion Drive BeltHow to Replace the Mower Drive Belt 42 Models English How to Replace the Primary Mower Drive Belt 46 & 52 Models Remove the primary mower drive belt from the stack pulleyEnglish How to Install the Wheels How to Replace the FuseFasten the rear wheel with washer and e-ring Storage over 30 days Troubleshooting Troubleshooting ChartPedal is depressed When the brake pedal is CorrectlyCut level Mower blades will notSpecifications Product SpecificationsEnglish English Year Limited Warranty Snapper Products Macon Street McDonough, GA

SLT23460 LT195420, CLT195420, LT23460, CLT23460, LT24520, CLT24520, SLT23460, SLT24520, CLT195420, LT23460, CLT23460, LT24520, LT195420, CLT195420,, LT23460, CLT23460, LT24520, CLT24520, SLT23460, SLT24520, CSLT23460, CSLT24520, SLT23460FC, SLT24520FC, LT195420, CLT195420, LT23460, CLT23460, LT24520, CSLT24520, SLT23460, SLT24520, CSLT23460, CSLT24520, SLT23460FC, SLT24520FC, LT195420, CLT195420, LT23460, CLT23460, LT24520, CLT24520, SLT23460, SLT24520, CSLT23460, CSLT24520, SLT23460FC, SLT24520FC, LT195420, CLT195420,, LT23460, CLT23460, LT24520, CLT24520, SLT23460, SLT24520, CSLT23460, CSLT24520 specifications

The Snapper lawn mower series, including models like LT195420, CLT195420, LT23460, CLT23460, LT24520, CLT24520, SLT23460, SLT24520, CSLT23460, CSLT24520, SLT23460FC, and SLT24520FC, showcases innovative features designed to provide convenience, performance, and efficiency in lawn care solutions. These mowers are particularly notable for their robust engineering and adaptability to various mowing conditions.

One of the key characteristics of the Snapper LT and CLT series is their powerful engine options. Each model is equipped with high-performance engines that ensure reliable starting, effective cutting power, and efficient fuel consumption. The LT195420 and CLT195420 models, for instance, feature a 19-inch cutting deck that enhances maneuverability and provides impressive cutting precision in tighter spaces.

The LT23460 and CLT23460 models, with their larger 23-inch cutting decks, cater to users looking for faster mowing capabilities without sacrificing quality. These mowers also incorporate a unique three-in-one cutting system, allowing users to choose between mulching, side discharge, or bagging clippings, depending on the lawn care needs.

The SLT and CSLT series take user comfort and ease of operation to the next level. These models feature ergonomically designed handles and comfortable seat systems that can be adjusted to suit the user's height, ensuring a pleasant mowing experience. Additionally, the SLT24520FC and SLT23460FC versions come with enhanced features for those who desire a more versatile approach to lawn maintenance.

Snapper’s commitment to innovation is evident in the incorporation of advanced technologies, including electric start capabilities and dual-blade cutting systems. This design maximizes cutting efficiency and results in a cleaner, more even finish on the lawn.

Durability is another hallmark of the Snapper mower lineup, with heavy-duty steel construction used in most models to ensure longevity, even in challenging mowing conditions. The series also includes features for easy maintenance, such as accessible oil and air filter locations, allowing homeowners to perform routine upkeep without hassle.

In summary, the Snapper LT195420, CLT195420, LT23460, CLT23460, LT24520, CLT24520, SLT23460, SLT24520, CSLT23460, CSLT24520, SLT23460FC, and SLT24520FC models are engineered for both performance and user convenience. Their combination of powerful engines, innovative cutting systems, and ergonomic designs make them an excellent choice for anyone looking to maintain a pristine lawn with ease and efficiency.
Top Page Image Contents