Snapper specifications Towing, Maintenance

Page 6

!

Important Operator Safety Instructions (Continued)

!

Towing

1.Tow only with a machine that has a hitch designed for towing. DO NOT attach towed equipment except at the hitch point.

2.Follow the manufacturer’s recommendation for weight limits for towed equipment and towing on slopes.

3.DO NOT allow children or others on towed equipment.

4.On slopes, the weight of the towed equipment may cause loss of traction and loss of control.

5.Travel slowly and allow extra distance to stop.

Maintenance

1.DO NOT store machine or fuel container inside where fumes may reach an open flame, spark or pilot light such as in a water heater, furnace, clothes dryer or other gas appliance. Allow engine to cool before storing machine in an enclosure. Store fuel container out of the reach of children in a well ventilated, unoccupied building.

2.Keep engine free of grass, leaves or excess grease to reduce fire hazard and engine overheating.

3.When draining fuel tank, drain fuel into an approved container outdoors and away from open flame.

4.Check brakes frequently; adjust, repair or replace as needed.

5.Keep all bolts, nuts and screws properly tight. Check that all cotter pins are in proper position.

Maintenance

(Continued From Previous Column)

6.Always provide adequate ventilation when running engine. Exhaust gases contain carbon monoxide, an odorless and deadly poison.

7.Disconnect negative (black) cable from battery before performing maintenance or service. Cranking engine could cause injury.

8.DO NOT work under machine without safety blocks.

9.Service engine and make adjustments only when engine is stopped. Remove spark plug wire(s) from spark plug(s) and secure wire(s) away from spark plug(s).

10.DO NOT change engine governor speed settings or overspeed engine.

11.Lubricate machine at intervals specified in manual to prevent controls from binding.

12.Mower blades are sharp and can cut. Wrap the blades or wear heavy leather gloves and use CAUTION when handling them.

13.DO NOT test for spark by grounding spark plug next to spark plug hole; spark plug could ignite gas exiting engine.

14.Have machine serviced by an authorized SNAPPER dealer at least once a year and have the dealer install any new safety devices.

15.Maintain or replace safety and instruction labels as necessary.

16.Use only genuine SNAPPER replacement parts to assure that original standards are maintained.

English

4

www.snapper.com

Page 5 Page 7
Image 6
Page 5 Page 7
Contents Lawn Tractor Series Where to Find Us Mower EngineDate Purchased Table of Contents Preparation Protection for ChildrenProtection against Tipovers Do not allow pre-teenage children to operate machineSafe Handling of Gasoline Towing International Pictorials GhijAssembly Parts Bag ContentsInstalling the Seat Assembling the Steering WheelMaintenance Free Battery How to Install the Battery CablesIMPORTANT! Before You Start Mowing Remove the protective cap from the battery terminalHow To Check The Safety Interlock Switches Operator Presence System SeatHow to Prepare the Engine Check the TiresCheck the Level of the Mower Deck Features and Controls How to Engage the Blades 42 Models Using ControlsHow to Use the Throttle Control OperationHow to Engage the Blades 46 & 52 models How to Use the Speed Control PedalDriving and Stopping the Unit How to Change Direction How to Use the Cruise ControlHow to Drive in Reverse Push the brake pedalHow to Set the Parking Brake How to Change the Cutting HeightHow to Stop the Unit Remove the key to restrict access to the RMO feature How to Transport the UnitHow to Operate the Mower Deck MowingHow to Operate the Unit on Hills How to Stop on a HillHow to Start Operation on a Hill Before Starting the Engine Check the Oil How to Start the EngineEngine Operation Add GasolineMowing and Bagging Tips TipsOperating Tips Use the left side of the mower deck to trim near an objectFrequency Maintenance Required Comments MaintenanceMaintenance Schedule Maintenance engine Examine bladesGeneral Recommendations How to Check the MufflerHow to Remove and Install the Blade InspectionAdjustments How to Sharpen the BladeHow to Adjust the Blade Rotation Control 42 Models Blade engage cable adjustment Blade engage cable bracket How to Check and Adjust the PTO Clutch 46 & 52 Models Blade Brake Check 46 & 52 Models OnlyHow to Check and Adjust the Motion Drive Belt Remove the 1/4 inch 6 mm pin or bolt FigureHow to Charge the Battery How to Remove the BatteryHow to Clean the Battery Before you charge the battery, remove the batteryWhere to Lubricate LubricationHow to Install the Mower Deck 42 Models Mower Deck MaintenanceHow to Check the Fuel Filter Remove the mower drive belt from the stack pulleyMower driver belt V Belt guide Stack pulley How to Remove the Mower Deck 46 & 52 Models How to Install the Mower Deck 46 & 52 ModelsHanger rod Q Adjuster arm How to Adjust the Gauge Wheels How to Level the Mower DeckRemove the gauge wheels Figure Loosening adjuster knobs Lift link Adjuster knobs Replacing the Motion Drive BeltHow to Replace the Mower Drive Belt 42 Models English How to Replace the Primary Mower Drive Belt 46 & 52 Models Remove the primary mower drive belt from the stack pulleyEnglish How to Install the Wheels How to Replace the FuseFasten the rear wheel with washer and e-ring Storage over 30 days Troubleshooting Troubleshooting ChartCut level Pedal is depressed When the brake pedal isCorrectly Mower blades will notSpecifications Product SpecificationsEnglish English Year Limited Warranty Snapper Products Macon Street McDonough, GA

SLT23460 LT195420, CLT195420, LT23460, CLT23460, LT24520, CLT24520, SLT23460, SLT24520, CLT195420, LT23460, CLT23460, LT24520, LT195420, CLT195420,, LT23460, CLT23460, LT24520, CLT24520, SLT23460, SLT24520, CSLT23460, CSLT24520, SLT23460FC, SLT24520FC, LT195420, CLT195420, LT23460, CLT23460, LT24520, CSLT24520, SLT23460, SLT24520, CSLT23460, CSLT24520, SLT23460FC, SLT24520FC, LT195420, CLT195420, LT23460, CLT23460, LT24520, CLT24520, SLT23460, SLT24520, CSLT23460, CSLT24520, SLT23460FC, SLT24520FC, LT195420, CLT195420,, LT23460, CLT23460, LT24520, CLT24520, SLT23460, SLT24520, CSLT23460, CSLT24520 specifications

The Snapper lawn mower series, including models like LT195420, CLT195420, LT23460, CLT23460, LT24520, CLT24520, SLT23460, SLT24520, CSLT23460, CSLT24520, SLT23460FC, and SLT24520FC, showcases innovative features designed to provide convenience, performance, and efficiency in lawn care solutions. These mowers are particularly notable for their robust engineering and adaptability to various mowing conditions.

One of the key characteristics of the Snapper LT and CLT series is their powerful engine options. Each model is equipped with high-performance engines that ensure reliable starting, effective cutting power, and efficient fuel consumption. The LT195420 and CLT195420 models, for instance, feature a 19-inch cutting deck that enhances maneuverability and provides impressive cutting precision in tighter spaces.

The LT23460 and CLT23460 models, with their larger 23-inch cutting decks, cater to users looking for faster mowing capabilities without sacrificing quality. These mowers also incorporate a unique three-in-one cutting system, allowing users to choose between mulching, side discharge, or bagging clippings, depending on the lawn care needs.

The SLT and CSLT series take user comfort and ease of operation to the next level. These models feature ergonomically designed handles and comfortable seat systems that can be adjusted to suit the user's height, ensuring a pleasant mowing experience. Additionally, the SLT24520FC and SLT23460FC versions come with enhanced features for those who desire a more versatile approach to lawn maintenance.

Snapper’s commitment to innovation is evident in the incorporation of advanced technologies, including electric start capabilities and dual-blade cutting systems. This design maximizes cutting efficiency and results in a cleaner, more even finish on the lawn.

Durability is another hallmark of the Snapper mower lineup, with heavy-duty steel construction used in most models to ensure longevity, even in challenging mowing conditions. The series also includes features for easy maintenance, such as accessible oil and air filter locations, allowing homeowners to perform routine upkeep without hassle.

In summary, the Snapper LT195420, CLT195420, LT23460, CLT23460, LT24520, CLT24520, SLT23460, SLT24520, CSLT23460, CSLT24520, SLT23460FC, and SLT24520FC models are engineered for both performance and user convenience. Their combination of powerful engines, innovative cutting systems, and ergonomic designs make them an excellent choice for anyone looking to maintain a pristine lawn with ease and efficiency.
Top Page Image Contents