Snapper 7800849 manual Stopping the Mower Cutting Height Adjustment, Handle Height Adjustment

						Operation
Stopping the Mower				Cutting Height Adjustment
1. Stop forward motion of the mower by releasing the				!	WARNING
wheel drive control.						!
2. Stop the engine and blade by releasing the blade				DO NOT attempt any maintenance, adjustments or
control.				service with engine and blade running. STOP engine
Handle Height Adjustment				and blade. Disconnect spark plug wire and secure
				HOT. Avoid serious burns, allow sufficient time for all
				away from spark plug. Engine and components are
!	WARNING		!	components to cool.
DO NOT attempt any maintenance, adjustments or				1. Pull the height adjusting latch (A, Figure 6) out-
service with engine and blade running. STOP engine				ward and move to the desired cutting height.
and blade. Disconnect spark plug wire and secure
away from spark plug. Engine and components are
HOT. Avoid serious burns, allow sufficient time for all
components to cool.
The height of the mower handle can be adjusted as fol-
lows:			each
1. Loosen the lower nuts (A, Figure 5)
lower handle.		Reproduction
2. Move the handle assembly (B) up or down until
the desired position is achieved.
3. Tighten the lower nuts on each lower handle to						A
maintain the desired position.
				Fig	re 6: Adjusting cutting height
				2. Set all wheels at the same cutting height. The
				highest cutting position is Notch 7 (Figure 7). The
			B	lowest cutting position is Notch 1.
	A
Figure 5: Adjusting the handle height
				1.25 in		4.00 in
				3,18 cm		10,16 cm
				Figure 7: Cutting height settings (approximate)

en

13