Maintenance
Driven Disc Replacement (Continued) | Driven Disc Bearing Replacement |
2. Using needle nose pliers, unhook the drive spring |
| ! | WARNING |
|
| ! | ||
(A, Figure 29) and slide the driven disc assembly |
|
|
| |||||
off the hex shaft. |
|
| DO NOT attempt any maintenance, adjustments or | |||||
3. Remove the five machine screws (A, Figure 30) |
| service with engine and blade running. STOP engine | ||||||
and plate (B) which secure the rubber ring (C) to |
| and blade. Disconnect spark plug wire and secure | ||||||
the driven disc hub (D). |
|
| away from spark plug. Engine and components are | |||||
4. Install a new rubber ring. |
|
| HOT. Avoid serious burns, allow sufficient time for all | |||||
5. Reverse the above procedures for reassembly and | components to cool. |
|
|
|
| |||
installation of the driven disc assembly. |
| 1. Remove the driven disc assembly. Refer to the |
| |||||
|
|
| Section entitled “Driven Disc Replacement”. |
|
| |||
|
|
| 2. Remove the snap ring (A, Figure 31) that secures | |||||
|
|
| the driven disc hub (B) to the thrust plate. |
|
| |||
|
|
| 3. Slide the driven disc hub out of the bearing (C). | |||||
|
|
| 4. Remove the four screws, and replace the bearing. | |||||
|
|
| 5. Reassemble the components in reverse order. |
| ||||
|
|
| NOTE: Be sure to replace the shim washer (D) when | |||||
A | CReproduction |
|
|
|
| |||
|
| reassembling the driven disc assembly. |
|
|
| |||
| Not | for |
| A |
|
|
| |
|
|
|
| C |
|
|
|
|
Figure 29: Removing the driven disc assembly |
|
|
|
|
| D | ||
|
|
|
|
|
|
| ||
A |
|
|
|
|
| B |
|
|
D |
|
|
|
|
|
|
| |
|
|
|
|
|
|
|
| |
|
|
| Figure 31: Replacing the driven disc bearing |
|
| |||
B |
Figure 30: Replacing the driven disc rubber ring
en
25