|
|
|
|
|
|
| Operation | |
Installing the Grass Bag |
|
| Installing the Mulching Plug |
| ||||
Adapter |
|
|
|
| (Optional Accessory on Some Models) |
| ||
(Optional Accessory on Some Models) | ! |
| ! | WARNING | ! | |||
| ! | WARNING |
|
| service with engine and blade running. STOP engine | |||
|
|
|
|
|
| DO NOT attempt any maintenance, adjustments or | ||
DO NOT attempt any maintenance, adjustments or |
| and blade. Disconnect spark plug wire and secure | ||||||
service with engine and blade running. STOP engine |
| |||||||
| away from spark plug. Engine and components are | |||||||
and blade. Disconnect spark plug wire and secure |
| |||||||
| HOT. Avoid serious burns, allow sufficient time for all | |||||||
away from spark plug. Engine and components are |
| |||||||
| components to cool. |
| ||||||
HOT. Avoid serious burns, allow sufficient time for all |
|
| ||||||
components to cool. |
|
|
| 1. Install the mulching plug (A, Figure 11) if mulching | ||||
1. | Remove the mulching cover. Refer to the Section |
| is desired after the bag adapter is installed. Install | |||||
| the mulching plug completely and securely into the | |||||||
| entitled “Removing the Mulching Cover”. |
|
| |||||
|
|
| bag adapter (B). |
| ||||
2. | Install the adapter (A, Figure 10) to the deck in |
|
| |||||
| 2. Install the grass bag as a safeguard. |
| ||||||
| place of the mulching cover, making sure that: |
|
|
| ||||
• |
|
| 3. Refer to the Section entitled “Mulching Operation”. | |||||
The front hole (B) on the outside front of the adapt- | ||||||||
| er fits over the stud where the front of the mulching |
|
|
| ||||
| cover was originally secured; | ReproB duction |
| |||||
|
|
|
| |||||
• | The slot (C) on top of the adapter slips under the | for |
|
| ||||
| restraining nut on top of the deck (under the right |
|
|
|
| |||
• | front corner of the engine); |
|
|
|
| A |
| |
The slot (D) on the rear of the adapter slips onto |
|
|
| |||||
| the stud behind the rear of the discharge opening, |
|
|
|
| |||
| where the rear of the mulching cover was originally |
|
|
| ||||
3. | secured. |
|
|
|
|
|
|
|
Install the nuts onto the studs and tighten securely. |
|
|
| |||||
4. | Route the recoil rope around the outside of the |
|
|
| B |
| ||
| rope guide pulley (E). |
|
|
|
|
| ||
NOTE: The recoil rope may need to beNotslackened. |
|
|
|
| ||||
Refer to the section entitled “Starting the Mower”. |
|
|
|
|
| |||
|
| E |
|
|
| Figure 11: Installing the mulching plug |
| |
|
|
|
|
|
|
|
| |
|
|
| C |
|
|
|
|
|
D |
A |
Figure 10: Installing the grass bag adapter
en
15