Snapper EFRP216516BV Propelling Mower, Self Propelled Models Only, Cutting Height Adjustment

Section 2 - OPERATING INSTRUCTIONS

2.2.2.PROPELLING MOWER

(Self Propelled Models Only)

1.Move ground speed control to the desired speed position. See Figure 2.4.

2.Move wheel drive control against handle to engage wheel drive and propel mower forward. Forward speed can be adjusted while the mower is moving by changing position of the ground speed control. See Figure 2.4.

MOVE GROUND	RECYCLING MODEL SHOWN
	(ROPE START MOUNTED ON
SPEED CONTROL TO
	RIGHT SIDE OF HANDLE)
DESIRED POSITION

2.Move upper mower handle up or down until the desired position is achieved.

3.Tighten the lower nuts on each lower handle to maintain desired position.

WARNING

STOP engine and mower blade by releasing the blade control before adjusting cutting height or handle height.

2.5 CUTTING HEIGHT ADJUSTMENT

(FAST)

SIXTH SPEED POSITION

SIX

(SLOW)

ONE ONE SPEED POSITION

WHEEL DRIVE CONTROL

1. Pull the height adjusting latch outward and move

to desired cutting height. See Figure 2.6.

1	LOWEST CUTTING	LATCH
	HEIGHT

BLADE

CONTROL

FIGURE 2.4

1

2

3

4

5

HIGHEST CUTTING

6

2.3 STOPPING

Stop engine and blade by releasing the blade

control. Stop forward motion of mower by releasing

the wheel drive control.

6

HEIGHT

2.4 HANDLE HEIGHT ADJUSTMENT

The height of the mower handle can be adjusted as

follows:

1.Loosen the lower nuts on each lower handle as

FIGURE 2.6

2. Set all wheels at the same cutting height. The

highest cutting position is Notch 6. The lowest

cutting position is Notch 1. See Figure 2.7.

shown in Figure 2.5.

LOWER

HANDLE

HIGHER

LOWER

LOOSEN LOWER

NUTS ON EACH

LOWER HANDLE

LATCH

POSITIONS

CUTTING HEIGHT SETTINGS

FIGURE 2.7

FIGURE 2.5

7