Snapper EFRP216516BV Recycling Operation, Adjusting Front Deck Baffle, Example EFR216516BV

Section 2 - OPERATING INSTRUCTIONS

WARNING

DO NOT attempt any maintenance, adjustments or service with engine and blade running. STOP engine and blade. Disconnect spark plug wire and secure away from spark plug. Engine and components are HOT. Avoid serious burns, allow sufficient time for all components to cool.

2.6 RECYCLING OPERATION

NOTE: For best recycling results, cut up to a maximum of 1/3 of grass blade length and recycle ONLY when grass is dry.

1.	Set all wheels in the highest cutting position
(Notch 6).
2.	Move engine speed control to “FAST” (Rabbit)
position.

HOLE DESIGNATES TOP OF

BAFFLE (ALWAYS KEEP

HOLE IN UP POSITION)

FRONT DECK BAFFLE (SHOWN

IN HIGHEST POSITION)

WING NUT

FRONT CUTOUT OF DECK

FRONT

DECK

BAFFLE

WING

NUTS

MOVE BAFFLE UP FOR MULCHING GRASS

MOVE BAFFLE DOWN FOR GRASS BAGGING

3. Move ground speed control to slowest speed

setting.

4. Proceed mowing slowly. If grass is very dense,

lower each rear wheel latch one notch lower than

the front wheel latches to improve recycling

performance.

2.7 ADJUSTING FRONT DECK BAFFLE

(Models with an “F” prefix in model number)

(Example: EFR216516BV)

The front of the cutting deck on these models has

been modified with an open area. This allows the

blade to have more direct contact with the grass and

allows more air flow into deck chamber. The

adjustable baffle should be secured in the lowest

position when using a grass bag. The baffle should

be secured in the highest position when mulching

grass.

NOTE: Under certain conditions, when mulching, some grass may blow out from under front of baffle. This is normal but, the amount of grass blowing out can be reduced. Lower baffle slightly to reduce the amount of grass blow out.

1.Stop engine. See WARNING above.

2.Loosen wing nuts that secure front deck baffle. See Figure 2.8.

3.Lower the adjustable baffle to the lowest position when using a grass bag. Raise the baffle to its highest position when mulching grass. Take care to keep the baffle’s lower edge parallel to the bottom of the deck. See Figure 2.8.

4.Retighten wing nuts securely.

2.8INSTALLATION of GRASS CATCHER

Install grass catcher by sliding connector over flange of adapter. Attach grass bag hooks over middle handle cross bar. See Figure 2.9.

FIGURE 2.8

WARNING

DO NOT operate without entire Grass Catcher or guard in place. Grass Catcher components are subject to deterioration during normal use. Inspect frequently and replace worn or damaged components immediately.

FIGURE 2.9

8