Snapper E281222BE, E281022BE, E331522KVE Problem Probable Cause Corrective Action, Stop

Page 30

TROUBLESHOOTING

PROBLEM

 

PROBABLE CAUSE

 

CORRECTIVE ACTION

 

 

 

 

Engine Will Not

1. Fuel tank empty.

1.

Fill fuel tank with fresh fuel to proper level.

Start Using

2. Engine needs choking.

2.

Move choke control to “CHOKE” position.

Recoil Starter

3. Spark plug wire disconnected.

3.

Place spark plug wire onto spark plug.

 

4.

Faulty parking brake, blade or ignition switch.

4.

Contact authorized SNAPPER dealer.

 

5.

Park brake not engaged.

5.

Engage park brake.

 

6.

Ignition is in the OFF position.

6.

Turn ignition switch to the ON position.

Engine Will Not

1. Fuel tank empty.

1.

Fill fuel tank with fresh fuel to proper level.

Start Using

2. Engine needs choking.

2.

Move choke control to “CHOKE” position.

Electric Starter

3. Spark plug wire disconnected.

3.

Place spark plug wire onto spark plug.

 

4.

Faulty parking brake, blade or ignition switch.

4.

Contact authorized SNAPPER dealer.

 

5.

Park brake not engaged.

5.

Engage park brake.

 

6.

Blown Fuse.

6.

Replace with new 20 AMP fuse.

 

7.

Faulty interlock module.

7.

Contact authorized SNAPPER dealer.

 

8.

Ignition is in the OFF position.

8.

Turn ignition switch to the START position.

 

9.

Battery is weak or dead.

9. Charge or replace with new battery.

 

10. Battery cables loose, broken disconnected or

10. Clean and connect battery cables. If

 

 

corroded.

 

broken, replace with new battery cables.

 

11. Faulty electric starter or starter solenoid.

11. Contact authorized SNAPPER dealer.

 

12. Starter cable loose, broken or disconnected.

12. Connect starter cable. If broken, replace

 

 

 

 

with new starter cable.

 

13. Electrical wiring harness disconnected or broken.

13. Connect or replace with new wiring harness.

Engine Stalls After

1. Operator not in seat.

1.

Sit in operator’s seat.

Running

2. Choke control in the “CHOKE” position.

2. Move choke control to “OFF” position.

 

3.

Fuel tank empty.

3.

Fill fuel tank with fresh fuel to proper level.

 

4.

Engine air pre-cleaner and/or air cleaner dirty.

4.

Clean free of all debris.

 

5.

Spark plug defective or gap set improperly.

5.

Service spark plug.

 

6.

Fuel filter restricted.

6.

Replace fuel filter.

 

7.

Water, debris or stale fuel in fuel system.

7.

Drain and clean fuel system.

 

8.

Vent on fuel cap closed.

8.

Open vent.

Engine Loses

1. Excessive load on engine.

1.

Lessen load.

Power

2. Engine air pre-cleaner or air cleaner dirty.

2.

Clean or replace filters.

 

3.

Spark plug faulty.

3.

Service spark plug.

 

4.

Water, debris or stale fuel in fuel system.

4.

Drain and clean fuel system. Replace filter.

 

5.

Debris build up on engine cooling screen.

5. Clean all debris from engine cooling screen.

Engine Backfires

1. Throttle control set too “FAST”.

1. Set throttle control to “SLOW” and allow

When Turned To

 

 

 

engine to idle. Then, turn key to “OFF”.

“STOP”

 

 

 

 

Excessive Vibration

1. Damaged, out of balance or bent mower blades.

1.

Service mower blade(s).

 

2.

Loose blade components.

2.

Service and tighten loose parts.

 

3.

Loose or missing air lift (if equipped).

3.

Replace air lifts. Tighten to proper torque.

 

4.

Lumpy or frayed belt.

4.

Replace belt.

 

5.

Bent Idler, stationary or spindle pulley.

5.

Replace pulley.

(Trouble Shooting Continued on Next Page)

30

Image 30
Contents European Rear Engine Riding Mower Series Manual No -4391 I.R /19/01Important Safety Instructions Operation Table of Contents Introduction NomenclatureFamiliarization Decals / Symbols Lowest Height CUT Battery Caution OPERATOR’S Seat Adjustment 2.2.1. Front to Rear Adjustment PRE-START Check ListStarting & Operation Engine Electric Start On NextStarting & Operation Engine Electric StartEngine Manual Start Starting & Operation 2.3.3. Mower Blade Wheel DriveStopping ENGINE, Wheel DRIVE, Blade 2.4.1. Engine Mower BladeCutting Height Adjustment Stopping ENGINE, Wheel DRIVE, Blade 2.4.4. Park BrakeDo not park machine on slopes Reverse Lockout Mechanism Reverse Lockout Mechanism OverrideService After First 5 Hours Change Engine OIL Service Engine AIR Cleaner Check Mower BladeService After First 5 Hours 3.2.4. Check Blade Drive Belt Service Brake / Park BrakeBlade Brake Clean Mower Deck Service Every 25 Operating HoursBattery Fluid Level Interlock SystemService Every 25 Operating Hours from previous Front Wheel Bearing LubricationRear Axle Bearing Lubrication Fuel Filter Service AnnuallyEngine Every TWO YearsStorage OUT of Season Removing Fuel TankEngine Adjustments & Repair Mower Drive Belt Adjustment for 28 Decks onlyBlade Brake Adjustment Mower Deck Adjustment Side-To-Side LevelnessMower Deck Adjustment Front to Rear Levelness 28 & 33 DecksChain Case Clutch Yoke Cable Housing Spring Mower Blade Replacement 4.4.1. Blade Wear Limits Blade SharpeningBelt Removal Blade Drive Belt ReplacementBelt Replacement DecksBattery Battery Removal Battery InstallationNEW Battery Preparation 1. Remove battery from carton Battery ServiceBattery Storage Battery TestingSnapper Rear Engine Rider Accessories Problem Probable Cause Corrective Action StopCutting Grass Loss Of TractionBlades Not Cutting ImproperlySubject Service Reference To be Performed PagesMAINTENANCE/REPLACEMENT Parts Maintenance Parts Year Limited Warranty Disclaimer of WarrantyService Notes European Rear Engine Riding Mower Series

E281022BE, E281222BE, E331522KVE, E331522KVE, E281022BE, E281222BE, E281222BE, E281022BE, E331522KVE specifications

The Snapper E281222BE, E281022BE, and E331522KVE models are part of Snapper’s extensive range of outdoor power equipment, known for their reliability and innovative features. These models are designed to cater to the needs of homeowners and professional landscapers alike, providing efficient and effective solutions for lawn care.

Starting with the Snapper E281222BE, this model stands out with its 21-inch cutting deck, which facilitates a wider cutting path, reducing mowing time. It is equipped with a powerful Briggs & Stratton engine that delivers strong performance, allowing for efficient cutting through various types of grass and terrain. The E281222BE also features a 3-in-1 mowing system, enabling users to mulch, bag, or side discharge grass clippings, offering versatility depending on the user's preference and yard conditions.

Next in line, the Snapper E281022BE presents a similar design but with slight modifications geared towards providing an economical and efficient solution for smaller lawns. This model also has a 21-inch cutting deck and shares the robust engine characteristics of its counterpart. However, it’s particularly known for its lightweight construction, making it easier to maneuver around tight spaces and flower beds. The E281022BE promotes excellent grass management with its easy-to-use height adjustment system that allows for customized cutting heights.

The E331522KVE model, on the other hand, offers additional features aimed at enhancing user experience. It boasts a larger 33-inch cutting deck, making it ideal for medium to large lawns. This model is powered by a powerful engine designed for high performance, while its variable-speed drive system allows for greater control over mowing speed. Furthermore, the E331522KVE integrates advanced technologies such as Smart-Cut™ technology, which adjusts power and speed automatically according to grass conditions, ensuring efficient grass management in varying scenarios.

All models feature durable construction with weather-resistant components, making them reliable choices for all seasons. Ergonomically designed handles and easy-to-access controls ensure comfort during extended use. Snapper’s commitment to sustainability is reflected in these models, as they are designed to maintain optimal fuel efficiency while minimizing emissions.

In conclusion, Snapper's E281222BE, E281022BE, and E331522KVE models offer a blend of power, efficiency, and ease of use. These characteristics make them suitable for various lawn care tasks while catering to the specific needs of the user. Whether you’re maintaining a small residential lawn or managing larger grassy areas, these Snapper models provide the performance and features necessary to achieve a beautifully manicured landscape.