Snapper SGT27540D manual Operating the Tractor

1.Return the ground speed control(s) to neutral and engage the parking brake.

2.Disengage the PTO and wait for all moving parts to stop.

3.Place the throttle control in the position specified in the engine owner’s manual provided in the operator's packet shipped with your tractor. Follow any recom- mended stopping procedures.

4.Turn the ignition switch to OFF. Remove the key.

Driving The Tractor

1.Sit in the seat and adjust the seat so that you can comfortably reach all the controls and see the dash- board display.

2.Engage the parking brake.

3.Make sure the PTO switch is disengaged.

4.Start the engine (see STARTING THE ENGINE).

5.Disengage the parking brake and release the brake pedal.

6.Depress the forward ground speed control pedal to travel forward. Release the pedal to stop. Note that the further down the pedal is depressed the faster the tractor will travel.

7.Stop the tractor by releasing the ground speed con- trol pedals, setting the parking brake, and stopping the engine (see STOPPING THE TRACTOR AND ENGINE).

Mowing

1.Engage the parking brake. Make sure the PTO switch is disengaged.

2.Start the engine (see STARTING THE ENGINE).

3.Set the hydraulic selector switch to REAR. Fully lower the mower using the attachment lift lever.

4.Set the mower cutting height to the desired level.

5.Set the throttle to FULL.

6.Set the PTO selector to MID PTO ONLY. Engage the PTO switch.

7.Begin mowing. See Section LC for tips on mowing patterns, lawn care, and troubleshooting information.

8.When finished, shut off the PTO and raise the mower using the attachment lift control lever.

9.Stop the engine (see STOPPING THE TRACTOR AND ENGINE).

Mowing in Reverse

Operating the Tractor

WARNING

The engine will shut off if the reverse ground speed pedal is depressed while the PTO is on and the RMO has not been activated. The operator should always turn the PTO off prior to driving across on roads, paths or any area that maybe used by other vehicles. Sudden loss of drive could create a hazard.

WARNING

Mowing in reverse can be hazardous to bystanders. Tragic accidents can occur if the operator is not alert to the presence of children. Never activate RMO if children are present. Children are often attracted to the unit and the mowing activity.

If an operator chooses to mow in reverse, the RMO sys- tem can be used. To use the Reverse Mowing Option (RMO) turn the RMO key after the PTO is engaged. The L.E.D. light will illuminate, and the operator can then mow in reverse. Each time the PTO is disengaged the RMO needs to be reactivated if desired. The key should be removed to restrict access to the RMO feature.

Attachment Operation in Reverse

If an operator chooses to operate a PTO driven attach- ment in reverse, the RMO system can be used. To use the Reverse Mowing Option (RMO) turn the RMO key after the PTO is engaged. The L.E.D. light will illumi- nate, and the operator can then operate the attachment in reverse. Each time the PTO is disengaged the RMO needs to be reactivated if desired. The key should be removed to restrict access to the RMO feature.

4-Wheel Drive Operation

(Select Models)

When operating in 4WD without a mower deck installed on the tractor, it is recommended you install rear wheel weights to increase stability.

WARNING

If you cannot back up a hill in 2WD, Do not operate on it. Use extra caution on slopes. To increase traction and provide four-wheel braking, engage mechanical front wheel drive (4WD) when driving on slopes. Be aware that 4WD can improve access to dangerously sloped terrain, thereby increasing the possibility of tipover.

15