Snapper SGT27540D manual Slope Operation, Safety Rules and Information

Page 5

Safety Rules and Information

Slope Operation

You could be seriously injured or even killed if you use this unit on too steep an incline. Using the unit on a slope that is too steep or where you don’t have adequate traction can cause you to lose control or roll over.

A good rule of thumb is to not operate on any slope you cannot back up (in 2-wheel drive mode). You should not operate on inclines with a slope greater than a 3.5 foot rise over a 20 foot length. Always drive up and down slopes: never cross the face.

Also note that the surface you are driving on can greatly impact stability and control. Wet grass or icy pavement can seriously affect your ability to control the unit.

If you feel unsure about operating the unit on an incline, don’t do it. It’s not worth the risk.

Moving Parts

This equipment has many moving parts that can injure you or someone else. However, if you are seated in the seat properly, and follow all the rules in this book, the unit is safe to operate.

The mower deck has spinning mower blades that can amputate hands and feet.

Do not allow anyone near the equipment while it is running!

To help you, the operator, use this equipment safely, it is equipped with an operator-present safety system. Do NOT attempt to alter or bypass the system. See your dealer immediately if the system does not pass all the safety interlock system tests found in this manual.

Thrown Objects

This unit has spinning mower blades. These blades can pick up and throw debris that could seriously injure a bystander. Be sure to clean up the area to be mowed BEFORE you start mowing.

Do not operate this unit without the entire grass catcher or discharge guard (deflector) in place.

Also, do not allow anyone in the area while the unit is running! If someone does enter the area, shut the unit off immediately until they leave.

Fuel and Maintenance

Gasoline is extremely flammable. Its vapors are also extremely flammable and can travel to distant ignition sources. Gasoline must only be used as a fuel, not as a solvent or cleaner. It should never be stored any place where its vapors can build up or travel to an ignition source like a pilot light. Fuel belongs in an approved, plastic, sealed gas can, or in the tractor fuel tank with the cap securely closed. Spilled fuel needs to be cleaned up immedi- ately.

Proper maintenance is critical to the safety and performance of your unit. Be sure to perform the maintenance procedures listed in this manual, espe- cially periodically testing the safety system.

3

Image 5
Contents Mfg. No. Description 27HP Hydro Tractors & Mower DecksMower Decks Page Table of Contents Safety Rules & Information Operating Safety Slope Operation Safety Rules and InformationGeneral Operation Safety Rules & InformationIgnition System Safe Handling of Gasoline Service & MaintenanceTractor ID Tag Mower ID Tag Identification NumbersCE Identification Tag Markings Safety Decals Safety DecalsDecal PTO Selector Positions Decal Danger, Rotating Fan CE, Diesel ModelsOperational Safety Checks Safety IconsControl Functions Features & Controls Automatic Controlled Traction Parking Brake FunctionDashboard Display Functions Slope Operation General Operating SafetyAdding Fuel Stopping The Tractor & EngineOperating the Tractor Pushing The Tractor By Hand Using Inboard HydraulicsHydraulic System Functions GeneralAuxiliary Hydraulics Angle Left Angle Right Using Auxiliary HydraulicsLocking The Hitch Attachment Weight LimitOptional 3-Point Hitch Operation Select Models Hitch Arms Installation Rear PTO Operation Select Models Connecting a Drive ShaftChecks Before Starting Starting & Stopping the PTOAttachment Recommendations Removing the Mower Deck Mower Deck Removal & InstallationMower Electrical Connection Installing the Mower DeckStorage Volt Power OutletAttaching a Trailer Before Every Spring Each Hours Fall Use Regular MaintenanceClean Radiator Regular MaintenanceClean Transmission Oil Cooler Check Engine Coolant LevelDrain Fuel Separator Service Interval Seasonally or as NeededCheck Transmission Oil Level Service Interval Every 25 HoursOil Filter Part No Change Transmission Oil & filterCheck Front Axle Oil Level Service Interval Every Fall & Spring Safety Interlock System CheckService Interval Every 100 Hours or Fall & Spring Check Mower Deck Gear Box OilCleaning the Battery and Cables Battery MaintenanceCheck Tire Pressures Size TreadOil LubricationGrease Lift Rod Grease Grease the ElectricFitting Yearly Arm Grease Fitting YearlyRemoving the Blade Servicing The Mower BladesMaintenance Records Troubleshooting Adjustment, & Service Troubleshooting the Mower Seat Adjustment Troubleshooting, Adjustment, & ServiceBrake Adjustment Seat Slide AdjustmentBattery Charging Headlight ReplacementTaillight & Dash Light Replacement Gauge Wheel Adjustment Mower AdjustmentsLeveling The Mower Side-to-Side Adjustment Lock Nut, 5/16-18 Spacer BoltTo avoid damaging belts, do not PRY Mower Belt ReplacementMower Drive Belt Replacement 27 HP* Briggs & Stratton SpecificationsMaintenance Items Replacement PartsOptional Accessories Technical Manuals

SGT27540D specifications

The Snapper SGT27540D is a robust and versatile lawn mower designed to cater to both residential and light commercial users. This model, known for its efficiency and ease of use, combines advanced technology with practical features, making yard maintenance a seamless task.

One of the standout features of the SGT27540D is its powerful 27 horsepower engine, which provides ample power for tackling various types of terrain and grass conditions. The engine’s design incorporates advanced cooling and lubrication systems, ensuring longevity and reduced maintenance needs. This lawn mower also features a self-propelled drive system, which allows users to effortlessly navigate through their yards without straining themselves.

The Snapper SGT27540D is equipped with a 54-inch cutting deck, facilitating a wide cutting swath that can efficiently cover large expanses of grass in a short amount of time. This deck features a robust steel construction for durability, and the adjustable cutting height offers versatility, allowing users to choose the perfect blade height based on their lawn’s requirements.

One of the defining technologies in the SGT27540D is the signature Snapper HiVac mowing system. This technology optimizes grass lifting, ensuring that even the toughest mowing jobs result in a clean and precise cut. As an added bonus, the HiVac system also improves grass clipping collection, making post-mowing cleanup a breeze.

Another notable characteristic of the Snapper SGT27540D is its user-friendly controls. The ergonomically designed steering lever allows for intuitive operation, while the dashboard provides essential information about speed and engine performance. For added comfort, the mower features an adjustable seat that can accommodate users of different heights.

The safety of operators is also a priority in the design of the SGT27540D. It is equipped with a reliable blade brake system that halts the blades quickly when necessary, minimizing the risk of accidents.

In summary, the Snapper SGT27540D is an exemplary lawn mower that marries durable construction with advanced technology. Its powerful engine, efficient cutting system, and user-friendly design make it a preferred choice for anyone seeking to maintain a pristine lawn with minimal effort and maximum results.