Quick SET-UP Guide

Hint: Use good quality Alkaline Batteries and avoid rechargeable batteries.

1.Have the intelligent weather station and remote temperature/humidity sensor 3 to 5 feet apart.

2.Batteries should be out of both the intelligent weather station and remote temperature/humidity sensor units for 10 minutes.

3.Place the batteries into the remote temperature/humidity sensor first and then into the intelligent weather station.

4.DO NOT PRESS ANY BUTTONS FOR 15 MINUTES.

In this time the intelligent weather station and remote temperature/humidity sensor will begin to communicate with each other and the display will show the temperature/humidity, outdoor temperature/humidity. If the intelligent weather station does not display all information after the 15 minutes, please retry the set up as stated above. After all information has been displayed for 15 minutes you can place your sensors outdoors and set your time.

Important Notes on Set-up and Operation

•The remote temperature/humidity sensor should be placed in a dry, shaded area.

•Fog and mist will not harm your remote temperature/humidity sensor but direct rain must be avoided.

•The remote temperature sensor should be placed in a dry, shaded area. The remote temperature sensor has a range of 330 feet. Keep in mind that the 330 feet is in open air with no obstructions and that radio waves DO NOT curve around objects. Actual transmission range will vary depending on what is in the path of the signal. Each obstruction (roof, walls, floors, ceilings, thick trees, etc.) will effectively cut signal range in half.

Example: A wireless weather station receiver with a 330 feet range is mounted on an interior wall, so that the signal has to pass through one interior wall, one exterior wall, and across the 10 foot width of the room between the 2 walls. The first wall will reduce the range to 165 feet, and the second wall will reduce the range to