La Crosse Technology WS-9020U 915MHZ instruction manual AIR Pressure Tendency Indicator

Page 24

Note:

After initial set up of the intelligent weather station with the setting of the relative value, readings for weather forecasts should be disregarded for the next 12-24 hours. This will allow sufficient time for the intelligent weather station to collect air pressure data at a constant altitude and therefore result in a more accurate forecast.

If the intelligent weather station is moved to another location significantly higher or lower than its initial standing point (for example from the ground floor to the upper floors of a house), set again the relative air pressure value, and discard the weather forecast for the next 12-24 hours. By doing this, the intelligent weather station will not mistake the new location as being a possible change in air-pressure when really it is due to the slight change of altitude.

AIR PRESSURE TENDENCY INDICATOR

The air pressure tendency indicators are located on the left side of the air pressure display, below the weather icons, and they work independently from the weather forecast icons. The air pressure tendency indicator pointing upward or downward directions is displayed based on comparing the difference of the air pressure recorded during a full hour time frame.

Note:

An upward air pressure tendency indicator means that there is an increase in air pressure within the past 4 hours.

A downward air pressure tendency indicator means that there is an decrease in air pressure within the past 4 hours.

AIR PRESSURE

The fifth section of the LCD shows the relative air pressure and the air pressure history.

Air pressure changes in hPa

Air pressure over the last 12 hours

24

Image 24
Contents Features Intelligent Weather StationRemote TEMPERATURE/HUMIDITY Sensor Quick SET-UP Guide Important Notes on Set-up and OperationBattery Installation Battery Change Function Keys Intelligent weather stationSET key MAX/+ keyMIN/- key Alarm key LCD ScreenManual Settings LCD Contrast Setting 12/24 Hour Time Display SettingTime Zone Setting Daylight Time Saving ON/OFF Setting Manual Time SettingCalendar Setting Wwvb Time Reception ON/OFF SettingTemperature Unit Setting Relative AIR Pressure Unit SettingRelative Pressure Value Setting Language Display SettingTo Exit the Manual Setting Mode Outdoor Temperature and HumidityIndoor Relative Humidity and Indoor Temperature Toggling Between MIN/MAX Indoor and Outdoor RecordingsAdding Sensors Optional To SET-UP of Multiple Sensors When more than 1 transmitter used To View MIN/MAX Indoor and Outdoor RecordsTo View the MIN/MAX Data from Different Transmitters To Reset the MIN/MAX Values to Current Values Outdoor Channel RE-LEARN ModeWeather Alarm Setting To re-learn ALL channelsLOW Outdoor Temperature Alarm Setting High Outdoor Temperature Alarm SettingDefault alarm values Weather Alarm Operations Weather Alarms Alarm setting Minimum Maximum HysteresisWeather data Hysteresis Examples of changing weather icons Sunny Cloudy with Rainy IntervalsAIR Pressure Tendency Indicator AIR PressureBAR Graph Display AIR Pressure HistoryLOW Battery Indicator Weather InformationdisplayDetailed Information Shown in the Weather Display Remote TEMPERATURE/HUMIDITY Sensor / 915MHZ Reception Check Page Positioning the Intelligent Weather Station To wall mountPositioning the Remote Temperature / Humidity Sensor To wall mountCare and Maintenance SpecificationsWarranty Information Page FCC Disclaimer Statement according to FCC part