Cub Cadet 2166 manual General Battery Information, Maintenance of Battery, Storage of the Battery

Page 30

GENERAL BATTERY INFORMATION

WARNING

a. Battery posts, terminals and related accessories contain lead and lead compounds. Wash Hands after handling.

b.Battery acid must be handled with great care, as contact with it can burn and blister the skin. It is advisable to wear protective clothing (goggles, rubber gloves and apron) when working with acid.

c.Should battery acid accidentally splatter into the eyes or onto the skin, rinse the affected area immediately with clean cold water. If there is any further discomfort, seek prompt medical attention.

d.If acid spills on clothing, first dilute it with clean water, then neutralize with a solution of ammonia/water or baking soda/water.

e.Since battery acid is corrosive, do not pour it into any sink or drain. Before discarding an empty electrolyte container, rinse it thoroughly with a neutralizing solution.

f.NEVER connect (or disconnect) battery charger clips to the battery while the charger is turned on, as it can cause sparks.

g.Keep all sources of ignition (cigarettes, matches, lighters) away from the battery. The hydrogen gas generated during charging can be combustible.

h.As a further precaution, only charge the battery in a well ventilated area.

ALWAYS SHIELD EYES AND PROTECT SKIN AND CLOTHING WHEN WORKING NEAR BATTERIES.

DANGER

BATTERIES CONTAIN SULFURIC ACID AND MAY EMIT EXPLOSIVE GASES. USE EXTREME CAUTION WHEN HANDLING BATTERIES.

KEEP BATTERIES OUT OF THE REACH OF CHILDREN.

MAINTENANCE OF BATTERY

The tractor is shipped with a wet battery — the battery acid has already been added and the battery sealed. Although the battery is maintenance free, the following care should be taken when handling the battery and to assure its proper life cycle.

1.Spray the terminals and exposed wire with a battery terminal sealer, or coat the terminals with a thin coat of grease or petroleum jelly, to protect against corrosion.

2.The battery should be kept clean. Any deposits of acid should be neutralized with baking soda and water. Be careful not to get this solution in the cells.

3.Avoid tipping the battery. Even a “sealed” battery will leak electrolyte when tipped.

STORAGE OF THE BATTERY

1.When storing the tractor for extended periods, disconnect the battery cables. Removing the battery from the unit is recommended.

2.All batteries discharge during storage. Keep the exterior of the battery clean, especially the top. A dirty battery will discharge itself more rapidly.

3.The battery must be stored with a full charge. A discharged battery will freeze at a higher temperature.

Specific Gravity

Freezing Point

1.265

–71°F

1.250

–62°F

1.200

–16°F

1.150

5°F

1.100

16°F

COMMON CAUSES FOR BATTERY FAILURE

1.Overcharging

2.Undercharging

3.Loose and/or corroded connections

4.Excessive loads

5.Freezing of electrolyte

*These causes do not constitute warranty in the event of a battery failure.

30

Image 30
Contents Important Read Safety Rules and Instructions Carefully OPERATOR’S ManualMANUFACTURER’S Warranty Coverage Contents Tractor and Deck PreparationSafe Operation Practices General OperationII. Slope Operation Do notIII. Children IV. Service Deflector and Safety Graphic Product GraphicsCalling Service Information To the OwnerRecording Model and Serial Number Information Section I. Controls and Indicators Safety Interlock Switches Not ShownIGNITION/LIGHT Switch LOW OIL IndicatorPower TAKE-OFF PTO Control Switch Hour MeterBrake Pedal Lift Height IndicatorSeat Adjustment Lever Forward Control PedalSafety Interlock Switches Fuel TankHood and Side Panels Page Section II. Operation Before Operating Your TractorStarting the Engine Tractor BREAK-IN Procedure Stopping the EngineCold Weather Starting Driving the Tractor Stopping the Tractor Operating the Power TAKE-OFF PTO ClutchDriving on Slopes DrawbarSection III. Adjustments Adjusting the SeatAdjusting the Brakes Front Wheel Adjustment Pivot BAR AdjustmentWheel Alignment Hydrostatic Neutral Adjustment Checking the Transmission Neutral SettingControl Adjusting Lift Assist Spring TensionFront Control Rod Rear Control Rod Hex Tap Screw Pivot Sleeve Neutral ArmCarburetor Adjustments Engine OIL Section IV. MaintenanceEngine Maintenance Checking the OIL LevelDraining OIL and Replacing OIL Filter Filling the Crankcase Checking Transmission OIL LevelAdding Transmission OIL Hydrostatic Drive OIL FilterAIR Cleaner Servicing the PrecleanerCleaning Engine Servicing the Paper ElementSpark Plug Fuel Filter HeadlightsStorage of the Battery General Battery InformationMaintenance of Battery Common Causes for Battery FailureBattery Installation Battery Removal or InstallationBattery Removal Wash Hands after handlingTires Tire Size Pounds per Square InchMounting Tires on the RIM SIDE-TO-SIDE Leveling Adjustment Section V. Mower DeckFront to Back Leveling Adjustment Finger guard Blade Hard Level Surface Measure This DistanceGauge Wheel Adjustment Washer Cutting Height AdjustmentFlat Rear Gauge WheelRemoval and Installation of Deck Assembly Removal of DeckFront Lift ROD Roller Bracket Installation of Deck Front Roller Bracket Lift ROD Install the forward end of the PTO belt on the PTO Maintenance Cleaning and Blade CareLubrication Installation of Mulching Plug Spindle Drive Belt ReplacementSection VI. OFF-SEASON Storage Section VII. Mowing MowingMowing with Mulching Option Optional Equipment and Accessories Maintenance Chart Month Season Yearly StorageHard to Start Engine Operates Irregularly or KnocksPTO Clutch will not Engage Maintenance Trouble ShootingLack of Power NanceLubrication Table Lubrication Guide Lubrication Guide Check OIL Level Before Each USE Slope Gauge Page Specifications EngineCUB Cadet LLC MANUFACTURER’S ONE Year Limited Warranty Commercial USECUB Cadet LLC MANUFACTURER’S Limited Warranty Residential USEMaintenance Parts Chart