Cub Cadet 2166 manual Lubrication Table

LUBRICATION TABLE

	Check	Change		Anticipated Air Temperature
Point of	at	at	Capacity
Lubrication	Hours	Hours		Above + 32°F	Below + 32°F
Engine crankcase	Check	100	Approx.	Cub Cadet	Cub Cadet
	before		4 pints	Engine Oil SAE	Engine Oil SAE
	each			10W30 or 10W40	5W20 or 5W30
	use
Hydro transmission	Check	Add as	Approx.	Cub Cadet Drive System Fluid Plus
and transaxle with	before	needed	6 qts	NOTE: Cub Cadet Drive System Fluid Plus is specially
filter	each			formulated for this application. If any other oil is used
	use			Cub Cadet will not be responsible for substandard
				performance. Failures due to use of improper fluid
				are not covered by warranty. For maximum protec-
				tion, use Cub Cadet Drive System Fluid Plus.
Steering knuckles	10			Use 251H EP grease or equivalent No. 2 multi-
and front axle				purpose lithium grease and apply two strokes
pivot bolt				(minimum) or sufficient grease to flush out old
				grease and dirt.
Front wheel	30			Two strokes (minimum) of the lubricator using 251H
bearings				EP grease or equivalent No. 2 multi-purpose lithium
				grease.
Steering gear	30			Two strokes (minimum) of the lubricator using 251H
housing				EP grease or equivalent No. 2 multi-purpose lithium
				grease.
Deck spindles	10			Two strokes (minimum) of the lubricator using 251H
				EP grease or equivalent No. 2 multi-purpose lithium
				grease.
Spindle belt	10			Two strokes (minimum) of the lubricator using 251H
idler arm				EP grease or equivalent No. 2 multi-purpose lithium
				grease.
Deck Double Pulley	50			Use 251H EP grease or equivalent No. 2 multi-purpose
				lithum grease. Do not over lubricate.
Deck front gauge	50			Use 251H EP grease or equivalent No. 2 multi-purpose
wheels				lithum grease.
Foot and lift con-	10			Use a liberal amount of high grade lubricating oil.
trol pivot points

51