Craftsman 247.77012 manual This page applicable in the U.S.A. and Canada only

Page 34

(This page applicable in the U.S.A. and Canada only.)

Sears, Roebuck and Co., U.S.A. (Sears), the California Air Resources Board (CARB)

and the United States Environmental Protection Agency (U.S. EPA)

Emission Control System Warranty Statement (Owner’s Defect Warranty Rights and Obligations)

EMISSION CONTROL WARRANTY COVERAGE IS APPLICABLE TO CERTI- FIED ENGINES PURCHASED IN CALIFORNIA IN 1995 AND THEREAF- TER, WHICH ARE USED IN CALIFORNIA, AND TO CERTIFIED MODEL

YEAR 1997 AND LATER ENGINES WHICH ARE PURCHASED AND USED ELSEWHERE IN THE UNITED STATES (AND AFTER JANUARY 1, 2001 IN CANADA).

California and United States Emission Control Defects Warranty Statement

The California Air Resources Board (CARB), U.S. EPA and Sears are pleased to explain the Emission Control System Warranty on your model year 2000 and later small off-road engine (SORE). In California, new small off-road engines must be designed, built and equipped to meet the State’s stringent anti-smog standards. Elsewhere in the United States, new non-road, spark-ignition engines certified for model year 1997 and later must meet similar standards set forth by the U.S. EPA. Sears must warrant the emission control system on your

engine for the periods of time listed below, provided there has been no abuse, neglect or improper maintenance of your small off-road engine.Your emis- sion control system includes parts such as the carburetor, air cleaner, ignition system, muffler and catalytic converter. Also included may be connectors and other emission related assemblies. Where a warrantable condition exists, Sears will repair your small off-road engine at no cost to you including diagnosis, parts and labor.

Sears Emission Control Defects Warranty Coverage

Small off-road engines are warranted relative to emission control parts defects

part on your engine is defective, the part will be repaired or replaced by Sears.

for a period of one year, subject to provisions set forth below. If any covered

 

Owner’s Warranty Responsibilities

As the small off-road engine owner, you are responsible for the performance of the required maintenance listed in your Operating and Maintenance Instruc- tions. Sears recommends that you retain all your receipts covering maintenance on your small off-road engine, but Sears cannot deny warranty solely for the lack of receipts or for your failure to ensure the performance of all scheduled maintenance. As the small off-road engine owner, you should however be aware that Sears may deny you warranty coverage if your small off-road engine or a part has failed due to abuse, neglect, improper maintenance or unap-

proved modifications.You are responsible for presenting your small off-road engine to an Authorized Sears Service Dealer as soon as a problem exists. The undisputed warranty repairs should be completed in a reasonable amount of time, not to exceed 30 days.If you have any questions regarding your warranty rights and responsibilities, you should contact a Sears Service Representative at 1--800--469--4663. The emission warranty is a defects warranty. Defects are judged on normal engine performance. The warranty is not related to an in-use emission test.

Sears Emission Control Defects Warranty Provisions

The following are specific provisions relative to your Emission Control Defects Warranty Coverage. It is in addition to the Sears engine warranty for non-regulated engines found in the Operating and Maintenance Instructions.

1.

Warranted Parts

3.

No Charge

 

Coverage under this warranty extends only to the parts listed below (the

 

Repair or replacement of any Warranted Part will be performed at no

 

emission control systems parts) to the extent these parts were present on

 

charge to the owner, including diagnostic labor which leads to the

 

the engine purchased.

 

determination that a Warranted Part is defective, if the diagnostic work is

 

a.

Fuel Metering System

 

performed at an Authorized Sears Service Dealer. For emissions warranty

 

 

• Cold start enrichment system

 

service contact your nearest Authorized Sears Service Dealer as listed in

 

 

• Carburetor and internal parts

 

the “Yellow Pages” under “Engines, Gasoline,” “Gasoline Engines,” “Lawn

 

 

• Fuel Pump

 

Mowers,” or similar category.

 

 

4. Claims and Coverage Exclusions

 

b.

Air Induction System

 

 

Warranty claims shall be filed in accordance with the provisions of the

 

 

• Air cleaner

 

 

 

 

Sears Engine Warranty Policy. Warranty coverage shall be excluded for

 

 

• Intake manifold

 

 

 

 

failures of Warranted Parts which are not original Sears parts or because

 

c.

Ignition System

 

 

 

of abuse, neglect or improper maintenance as set forth in the Sears

 

 

• Spark plug(s)

 

 

 

 

Engine Warranty Policy. Sears is not liable to cover failures of Warranted

 

 

• Magneto ignition system

 

 

 

 

Parts caused by the use of add-on, non-original, or modified parts.

 

d.

Catalyst System

 

 

5.

Maintenance

 

 

• Catalytic converter

 

 

 

Any Warranted Part which is not scheduled for replacement as required

 

 

• Exhaust manifold

 

 

 

 

maintenance or which is scheduled only for regular inspection to the effect

 

 

• Air injection system or pulse valve

 

 

 

 

of “repair or replace as necessary” shall be warranted as to defects for the

 

e.

Miscellaneous Items Used in Above Systems

 

 

 

warranty period. Any Warranted Part which is scheduled for replacement

 

 

• Vacuum, temperature, position, time sensitive valves

 

 

 

 

as required maintenance shall be warranted as to defects only for the

 

 

and switches

 

period of time up to the first scheduled replacement for that part. Any

 

 

• Connectors and assemblies

 

replacement part that is equivalent in performance and durability may

2.

Length of Coverage

 

be used in the performance of any maintenance or repairs. The owner is

 

Sears warrants to the initial owner and each subsequent purchaser that

 

responsible for the performance of all required maintenance, as defined in

 

the Warranted Parts shall be free from defects in materials and workman-

 

the Sears Operating and Maintenance Instructions.

 

ship which caused the failure of the Warranted Parts for a period of one

6.

Consequential Coverage

 

year from the date the engine is delivered to a retail purchaser.

 

Coverage hereunder shall extend to the failure of any engine components

 

 

 

 

caused by the failure of any Warranted Part still under warranty.

In the USA and Canada, a 24 hour hot line, 1-800-469-4663, has a menu of pre-recorded messages offering you engine maintenance information.

34

Image 34
Contents Operator’s Manual Product Specifications Table of ContentsWarranty Model NumberRepair Protection Agreement Training Safety InstructionsPreparation Operation Maintenance & StorageDo not modify engine This page left intentionally blank Safety Labels To Avoid Serious InjuryRemoving Unit from Carton AssemblyOpening Carton Loose Parts in CartonAttaching the Handle Attaching the BAG Snap bag clip to the top of the lower handleLocking rod to secure chute in place, as in Figure Nozzle Height AdjustmentAttaching the Blower Chute SectionOperation Starter Handle Throttle ControlChoke Control GAS and OIL FILL-UPTo Start Engine Attach spark plug wire and rubber boot to spark plugTion when operating the Yard Vacuum To Stop EngineTo Empty BAG To Remove Blower ChuteServicing the Air Cleaner Service and MaintenanceEngine Maintenance General RecommendationsClean Equipment LubricationRemoving the Flail Screen Disconnect and ground the spark plug wire to retaining post Sharpening or Replacing Chipper BladeService and Maintenance Gas in the tank † Under heavy load or in high temperatures Maintenance ScheduleEach Use Engine oil level Check Preparing the Engine OFF-SEASON StoragePreparing the yard vacuum Troubleshooting Parts List Yard Vacuum Model NoDescription 121 11A 24 23 Height Adjustment Bearing Blower Chute Assembly781-04068 Upper Housing Pivot Arm AssemblyCraftsman 6.5 H.P. Engine Model No T02 For Yard Vacuum Model  1  engine gaSkeT SeT 299819S† Seal-Oil Magneto Side Cylinder AssemblyKit-Bushing/Seal Sump-Engine690662 692310 Switch-Stop66538S Boot-Spark Plug 281505692298 Cover-Air Cleaner 692017 Assembly-Dipstick/Tube496116 Base-Air Cleaner Primer 691669 Screw Air Cleaner Primer BracketSears Emission Control Defects Warranty Provisions Sears Emission Control Defects Warranty CoverageOwner’s Warranty Responsibilities This page applicable in the U.S.A. and Canada onlyPage Especificaciones DEL Producto ÍndiceGarantía Número DE ModeloAcuerdo DE Protección Para Reparaciones Capacitación Instrucciones DE SeguridadPreparativos Mantenimiento y almacenamiento OperaciónNo modifique el motor Cómo Sacar LA Unidad DE LA Caja MontajeApertura DE LA Caja DE Cartón Piezas Sueltas Dentro DE LA CajaMontaje DE LA Manija FiguraMontaje DE LA Bolsa Cuando deslice la varilla de seguridad. Vea la figura Instalar EL Canal DE SopladoAjuste DE LA Altura DEL Pico En la siguiente secciónOperación Manija del arrancador Control del estranguladorControl de obturación Llenado DE Gasolina Y AceiteConecte el cable de la bujía y la manga de goma a la misma Para Encender EL MotorPara Detener EL Motor Mantenga Siempre el control del estrangulador en posiciónExtracción DEL Canal DE Soplado Descarga DE LA BolsaCortadora Mantenimiento de Motor MantenimientoRecomendaciones Generales Servicio a La BujíaLubricación Limpieza DEL EquipoExtracción DE LA Pantalla DE DES Granado Afilado O Reemplazo DE LAS Hojas DE LA Cortadora Retire el montaje de la bolsa o el canal de sopladoPico de plástico negro Tornillos con reborde Cada Uso Nivel del aceite de motor Comprobar Lista DE MantenimientoTanque † Bajo carga pesada o en temperaturas altas La preparación del vacío de yarda Almacenamiento Fuera DE TemporadaPreparación del Motor Ya que los motores almacenaron más de 30 díasSolución DE Problemas Motor y alojamiento de soplador El motor recalienta El nivel de aceite del motor es bajoFlujo de aire restringido Quite la bujía y ajuste el huecoEsta página se aplica sólo en EE.UU. y Canadá Piezas con garantíaMotor certificado Notas Get it fixed, at your home or ours

247.77012 specifications

The Craftsman 247.77012 is a versatile and powerful lawn tractor designed for homeowners seeking efficiency and ease of use in yard maintenance. Known for its robust construction and reliable performance, this model is particularly favored for its user-friendly features and advanced technology.

At the heart of the Craftsman 247.77012 is its durable 19-horsepower engine, providing ample power to tackle various terrain and grass types. This engine is equipped with a hydrostatic transmission, allowing for seamless speed adjustments without the need for gear shifting. This feature enhances maneuverability, making it easy to navigate around obstacles like trees and flower beds.

One of the standout characteristics of the 247.77012 is its cutting deck. Designed for a clean and precise cut, the 42-inch reinforced steel deck is equipped with mulching capabilities, enabling grass clippings to be recycled back into the lawn as natural fertilizer. This not only promotes healthier grass growth but also reduces the need for bagging and disposal.

The lawn tractor boasts a comfortable seating experience, featuring an adjustable high-back seat that offers excellent lumbar support. This ergonomic design ensures that users can operate the tractor for extended periods without discomfort. Additionally, the easy-to-read dashboard displays essential information such as fuel levels and engine status, enhancing the overall user experience.

In terms of technology, the Craftsman 247.77012 incorporates several innovative solutions to improve functionality. The tractor is compatible with optional attachments, including baggers and snow blades, transforming it into a year-round landscaping tool. This adaptability adds a great deal of value for those looking to extend the utility of their equipment.

Ease of maintenance is another vital feature of the Craftsman 247.77012. The model includes a built-in washout port, allowing for quick and hassle-free cleaning of the cutting deck after mowing. Routine maintenance tasks are made more accessible, ensuring that the lawn tractor remains in top condition and prolongs its lifespan.

Overall, the Craftsman 247.77012 is a reliable and efficient lawn care solution, merging power, comfort, and versatility to meet the needs of homeowners. With its blend of traditional craftsmanship and modern advancements, this lawn tractor stands out as a commendable choice for anyone looking to maintain their yard effortlessly.