3
Setting
Up Your
Chipper
Shredder
Vacuum
IMPORTANT: This unit is shipped without gasoline or oil in the engine. Be certain to service engine with gasoline and oil as instructed in the separate engine manual before operating your machine.
| Loose Parts In Carton | ||
|
| a. Upper and Lower Handle | |
|
| b. Hose Assembly | |
B |
| c. Safety Glasses | |
| d. Engine Oil (May be located in bag) | ||
|
| e. Bag | |
| NOTE: All references in this manual to the left or right | ||
A | side of the chipper shredder vacuum is from the operating | ||
| position only. Exceptions, if any, will be specified. | ||
Figure | Attaching The Handle | ||
1. | Remove the hairpin clips from the handle brackets and | ||
| |||
|
| remove the carriage screws and wing nuts from the | |
|
| lower handle. | |
|
| a. Place the bottom holes in lower handle over the | |
|
| pins on the handle brackets and secure with | |
|
| hairpin clips. See Figure | |
|
| b. Insert carriage screws through upper hole in lower | |
B |
| handle from the inside and secure with wing nuts. | |
| See Figure | ||
A | 2. | a. Unfold the upper handle until it aligns with lower | |
|
| handle. Make sure the rope guide is on the right | |
|
| side of upper handle. See Figure | |
| IMPORTANT: Make sure the cables are routed outside | ||
| the lower handle. Also, do not crimp the cables while | ||
| lifting up the handles. | ||
|
| b. Secure the two handles by tightening the star | |
|
| knobs (carriage bolts must be seated properly into | |
Figure |
| the handle). See Figure | |
3. | Pull the two cable ties attached to the cables tight | ||
| |||
|
| approximately 8 inches from each cable end and place | |
B |
| the cables into the cable guide. | |
| 4. Loosen the wing nut that secures the rope guide to the | ||
|
| right side of upper handle. | |
|
| a. Slowly pull starter rope out of engine. | |
|
| b. Slip the starter rope into the rope guide. Tighten the | |
|
| wing nut. See Figure |
A
Figure