Attaching The Hose Assembly
5.a. Slide hose adapter of hose assembly into the base adapter located on the left front of the Chipper shredder Vacuum. See Figure
b.Pull spring loaded pin out on the base and align pin with the first hole (closest to the end of the tube) in the hose adapter.
c.Release the pin to lock the hose in place.
6.a. Snap the hose handle first into the upper hose handle bracket and then into the lower hose handle bracket. See Figure
b.Lay hose tubing on hanger bracket next to chipper chute. See Figure
Attaching The Bag
7.Grasp bag handle with one hand and slide locking rod on mounting bracket with other hand toward engine. Use the end of mounting bracket as leverage when sliding the locking rod.
a.Slip bag over the rim of the discharge opening and release locking rod to secure bag in place. See Figure
b.Snap bag clip to the top of the lower handle.
c.Place the lower straps on the bag over the top of lower handle, hooking them on the studs. See Figure
NOTE: The bag/chute switch button attached to the mounting bracket must be fully depressed by the tip of front tab on bag handle when securing the bag or engine will not start.
A
B
Align pin with this
hole.
Figure
A
B
Figure
3
Setting
Up Your
Chipper
Shredder
Vacuum
B
A
C
Figure